Nugeon 99P00940A Disc Brake Caliper - Rear Right

Rear Right Brake Caliper for Accord and TSX

Nugeon TechShield 360 (tm) part number 99P00940A is a remanufactured rear right disc brake caliper built for specific Honda and Acura applications. It is listed for 1998-2007 Honda Accord and 2004-2008 Acura TSX rear right positions, with a supplied mounting bracket for the listed fitments.

Key Features

• Remanufactured cast iron caliper with rust preventative finish
• Grey caliper housing with steel piston
• 34 mm piston diameter for the specified rear brake application
• Bleeder screw included with M10-1.25 thread
• Banjo bolt inlet fitting with M10-1.0 inlet thread
• Caliper slides, dust boots, bracket, and brake pad hardware included
• Fits rear right position only

TechShield 360 (tm) Product Line

Nugeon TechShield 360 (tm) focuses on brake hydraulic components prepared for direct replacement service. For this caliper, the line centers on corrosion-resistant finishing, included service hardware, and application-specific fitment for Honda Accord and Acura TSX rear brake systems.

Detailed Description

This Nugeon 99P00940A disc brake caliper is engineered for the rear right side on 1998-2007 Honda Accord and 2004-2008 Acura TSX models. The remanufactured cast iron housing, steel piston, dust boots, and included slides support a complete hydraulic caliper replacement for the listed vehicles. The unit uses a banjo bolt inlet and includes a bleeder screw, making it a direct-match option for rear brake service on the Accord and TSX platform.

This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

Common Problems This Part Addresses

• Rear brake drag caused by a sticking caliper piston or slide
• Brake fluid seepage at the caliper body or bleeder area
• Uneven rear brake wear on the right side
• Corrosion-related caliper seizure on older Accord and TSX brake systems
• Reduced braking response from a worn hydraulic caliper assembly

Installation Notes and Tips

• Fits 2004-2008 Acura TSX, rear right.
• Fits 1998-2007 Honda Accord, rear right.
• Confirm the inlet fitting type is banjo bolt before installation.
• Verify M10-1.0 inlet thread and M10-1.25 bleeder thread match the vehicle brake line and service hardware.
• Inspect brake hoses, pads, and rotor condition during caliper replacement.
• Bleed the brake system after installation to remove air from the hydraulic circuit.

Quality Assurance

Built as a remanufactured brake hydraulic component with a rust preventative finish and application-specific hardware details for the listed Honda Accord and Acura TSX rear right fitments. Part number 99P00940A is identified for direct replacement use in the specified vehicle applications.