Nugeon 99P00944A Disc Brake Caliper - Front Left

Front Left Brake Caliper for Honda Accord

Nugeon TechShield 360 (tm) part 99P00944A is a remanufactured front left disc brake caliper for 2003-2007 Honda Accord applications. It includes a mounting bracket, bleeder screw, caliper slides, dust boots, and brake pad installation hardware with banjo bolt and copper crush washers where applicable.

Key Features

• Fits 2003-2007 Honda Accord, front left
• Remanufactured cast iron caliper with rust preventative finish
• Grey caliper housing with steel piston and one-piston design
• Includes bracket, bleeder screw, caliper slides, dust boots, and hardware
• Banjo bolt inlet fitting with M10-1.0 inlet thread size
• Bleeder screw thread: M10-1.25 x 25
• Housing cast numbers: 17CL-C, 0173
• Part number: 99P00944A

Product Details

The TechShield 360 (tm) product line focuses on brake hydraulics with corrosion-resistant finishing and application-specific remanufacturing. This Nugeon brake caliper is built for the front left position on the Honda Accord and uses a single 57 mm steel piston for hydraulic clamping force. The bracket is included for the listed applications, and the caliper arrives with a bleeder screw already installed.

Part number 99P00944A is a direct-fit disc brake caliper for 2003-2007 Honda Accord front left service work. It is a remanufactured replacement that matches the listed inlet and bleeder thread specifications for proper brake line connection and bleeding during brake service.

Common Repair Uses

• Restoring front left brake function on a Honda Accord with sticking or seized caliper movement
• Replacing a leaking caliper housing or damaged piston seal area
• Correcting uneven brake pad wear caused by caliper slide or piston issues
• Addressing brake pull, reduced braking response, or poor hydraulic release at the front left wheel
• Replacing a corroded caliper assembly during brake system service

Installation Notes

Verify the front left position, inlet thread size, and banjo bolt connection before installation. Transfer or replace brake pads as needed, since pads are not included. Bleed the brake system after installation and confirm proper pedal feel, fluid sealing, and caliper slide movement. Check rotor condition and pad wear before returning the vehicle to service.

Quality Assurance

This remanufactured Nugeon caliper is finished with a rust preventative coating and built with cast iron housing, steel piston construction, and included dust boots for brake system service. Confirm the housing cast numbers 17CL-C or 0173 and the listed fitment for 2003-2007 Honda Accord, front left before ordering.