Nugeon 99P00950A Disc Brake Caliper - Rear Right

Rear Right Brake Caliper for Honda Odyssey

This remanufactured Nugeon disc brake caliper is built for the rear right position on select 2005-2010 Honda Odyssey models. Part number 99P00950A is a direct-fit brake hydraulics component with a cast iron housing, grey rust-preventative finish, and included bracket for the listed application.

Nugeon TechShield 360 (tm) is the brand line used for this caliper platform, focusing on corrosion resistance and service-ready brake hardware details. For Honda Odyssey rear brake service, 99P00950A provides the key hydraulic and mounting features needed for a proper replacement.

• Fits 2005-2010 Honda Odyssey, rear right
• Remanufactured disc brake caliper with bracket included
• Cast iron housing with grey rust-preventative finish
• Single-piston design with 40 mm steel piston
• Bleeder screw included; dust boots and caliper slides included
• Banjo bolt inlet fitting with M10-1.0 inlet thread size
• Brake pad installation hardware included where applicable
• Part number 99P00950A for rear brake repair lookup

This rear right brake caliper is used to restore hydraulic clamping at the wheel end on the Honda Odyssey. It is a practical replacement when the original caliper shows corrosion, sticking, leakage, or uneven rear brake performance. The included bracket and slide components support the listed rear right fitment, while the rust-preventative finish helps protect the housing in everyday service.

• Rear brake drag caused by a sticking caliper
• Brake fluid seepage at the caliper body or bleeder area
• Uneven rear braking or pull during stops
• Corrosion on the original caliper housing or bracket
• Worn or seized slide movement at the rear right corner

Installation should follow the vehicle service procedure for 2005-2010 Honda Odyssey rear brake service. Verify the banjo bolt connection, bleeder screw thread size, and brake hose routing before installation. Because pads are not included, inspect pad condition and rotor surface during caliper replacement. Part number 99P00950A should be matched to the rear right position only.

Quality assurance for this Nugeon caliper centers on remanufactured brake hydraulics construction, cast iron durability, and corrosion-resistant finishing for the specified application. This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.