Nugeon 99P00952A Disc Brake Caliper - Rear Right

Rear Right Disc Brake Caliper for Honda Odyssey

This Nugeon TechShield 360 disc brake caliper is built for rear right brake service on select 2002-2004 Honda Odyssey models. Part number 99P00952A is a remanufactured caliper assembly with a grey rust-preventative finish, cast iron housing, and a single 38 mm steel piston for direct hydraulic braking function.

Key Features

• Fits 2002-2004 Honda Odyssey, rear right
• Nugeon TechShield 360 product line
• Part number 99P00952A
• Remanufactured disc brake caliper with bracket included
• Grey rust-preventative finish
• Cast iron housing with steel piston
• Bleeder screw included
• Caliper slides and dust boots included
• Banjo bolt inlet fitting
• Brake pad installation hardware included where applicable

Product Details

Nugeon TechShield 360 focuses on brake hydraulics components prepared for replacement service with attention to corrosion resistance and fitment consistency. This rear right caliper for the Honda Odyssey uses a 38 mm piston, M10-1.0 bleeder thread, and M10-1.0 inlet port thread with a banjo bolt connection. The bracket is included, and the housing carries cast numbers 3826 and WF for application matching. Part number 99P00952A is a practical choice when replacing a worn or sticking rear caliper on the 2002-2004 Honda Odyssey.

This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

What It Helps Address

• Rear brake drag caused by a sticking caliper piston or slide
• Uneven braking at the rear right wheel
• Brake fluid leakage at the caliper assembly
• Corrosion-related caliper seizure on older Honda Odyssey brake systems
• Brake pedal response issues tied to a worn hydraulic caliper

Installation Notes

Verify rear right position, bracket style, inlet fitting type, and cast numbers before installation. Transfer or replace brake pads as needed, and inspect the brake hose, banjo bolt sealing surfaces, and copper crush washers where applicable. Bleed the brake system after installation to remove air from the hydraulic circuit. Confirm rotor condition and slide movement before returning the vehicle to service.

Quality Assurance

Part number 99P00952A is a remanufactured Nugeon brake caliper from the TechShield 360 line, built with a rust-preventative finish, included dust boots, and included caliper slides for service-ready replacement on confirmed applications.