Nugeon 99P00953A Disc Brake Caliper - Front Left

Front Left Brake Caliper for Honda Pilot

Nugeon TechShield 360 (tm) part number 99P00953A is a remanufactured front left disc brake caliper for 2003-2008 Honda Pilot applications. It is built with a cast iron housing, a grey rust-preventative finish, and a 64 mm steel piston for direct brake hydraulic service on the front left corner.

Key Features

• Fits 2003-2008 Honda Pilot, front left
• Remanufactured disc brake caliper with bracket included
• Cast iron housing with rust-preventative finish
• 64 mm steel piston and dust boots included
• Bleeder screw included with M10-1.0 thread
• Caliper slides and brake pad installation hardware included
• Banjo bolt inlet fitting with copper crush washers where applicable
• Part number 99P00953A for catalog lookup and ordering

Product Details

The Nugeon TechShield 360 (tm) line focuses on brake hydraulic components with corrosion-resistant finishing and application-specific hardware details. This 99P00953A front left caliper is supplied with the mounting bracket and is configured for the Honda Pilot front brake position listed above. The housing cast numbers 6406 and L, along with the M10-1.0 inlet and bleeder thread sizes, support accurate replacement matching for the original brake assembly. If you are servicing a 2003-2008 Honda Pilot front left brake caliper, 99P00953A provides the core hydraulic component needed for a proper repair.

Common Problems This Part Addresses

• Brake fluid leakage from a worn caliper body or piston seal area
• Uneven front brake pad wear caused by sticking caliper movement
• Reduced braking response from a seized or corroded caliper assembly
• Noise or drag related to damaged caliper slides or dust boots
• Brake service issues on a Honda Pilot front left disc brake setup

Installation Notes and Tips

Verify the vehicle’s front left brake configuration, bracket style, inlet fitting, and thread sizes before installation. Transfer only the components required by the application and bleed the brake system after installation to remove air from the hydraulic circuit. Confirm rotor condition, pad wear, and hose routing during service to help ensure even brake operation on the Honda Pilot.

Quality Assurance

This remanufactured caliper is finished with rust-preventative coating and assembled with key service components for brake hydraulic replacement. TechShield 360 (tm) identifies the product line used by Nugeon for brake parts built around corrosion protection and application-matched fitment details.