Nugeon 99P00953B Disc Brake Caliper - Front Right

Front Right Brake Caliper for Honda Pilot

This Nugeon TechShield 360 disc brake caliper is a remanufactured front right replacement for select 2003-2008 Honda Pilot models. Part number 99P00953B is built for direct brake hydraulic service and includes the bracket for the listed application.

Key Features

• Fits 2003-2008 Honda Pilot, front right
• Remanufactured cast iron disc brake caliper
• Grey finish with rust preventative coating
• Includes bracket, caliper slides, dust boots, bleeder screw, and brake pad installation hardware
• Single-piston design with 64 mm steel piston
• Banjo bolt inlet fitting with M10-1.0 thread size
• Caliper and pad hardware included for the listed application

TechShield 360 Product Line

Nugeon TechShield 360 focuses on brake hydraulic replacement parts prepared for direct-fit service. For this Honda Pilot front right caliper, the line centers on corrosion-resistant finishing, correct mounting geometry, and the included service components needed for a proper brake repair on the listed vehicle application.

Detailed Description

Part number 99P00953B is a remanufactured disc brake caliper for the front right position on 2003-2008 Honda Pilot models. It uses a cast iron housing with a grey rust preventative finish, a steel piston, and a bracket included for the specified fitment. The caliper is supplied with a bleeder screw, dust boots, slides, and brake pad installation hardware, and it uses a banjo bolt inlet connection with M10-1.0 thread sizing. This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

Common Brake Issues This Part Can Address

• Leaking or sticking front right caliper on a Honda Pilot
• Uneven brake pad wear caused by caliper slide or piston problems
• Brake drag from a seized hydraulic caliper assembly
• Corrosion-related caliper housing damage
• Bleeding or service issues tied to worn caliper hardware

Installation Notes and Tips

Verify the front right position and confirm the bracket cast number 6406 and housing cast numbers 6406, R before installation. Use the correct banjo bolt and copper crush washers where applicable, and bleed the brake system after installation. Inspect brake pads, rotor condition, and hydraulic lines during service to complete the repair properly on the Honda Pilot.

Quality Assurance

Nugeon TechShield 360 remanufactured brake components are prepared for brake hydraulic replacement service with attention to fitment, hardware inclusion, and corrosion-resistant finishing for the listed application.