Nugeon 99P00961A Disc Brake Caliper - Rear Right

Rear Right Brake Caliper for Honda CR-V

This Nugeon TechShield 360 disc brake caliper is a remanufactured rear right replacement for 2007-2012 Honda CR-V models. Part number 99P00961A is built for direct brake hydraulic service with the correct bracket, bleeder screw, and slide hardware configuration for the listed application.

Key Features

• Fits 2007-2012 Honda CR-V, rear right
• Remanufactured cast iron disc brake caliper with grey rust-preventative finish
• TechShield 360 product line for corrosion-focused brake service
• Includes bracket, caliper slides, dust boots, and hardware
• Single 38 mm steel piston for rear brake operation
• Banjo bolt inlet fitting with M10-1.0 inlet thread size
• Bleeder screw included with M10-1.25 thread size

Detailed Description

Nugeon 99P00961A is a rear right disc brake caliper for the Honda CR-V, covering 2007-2012 model years. It uses a cast iron housing, steel piston, and a rust-preventative grey finish to support dependable brake hydraulic performance in the rear brake system. The TechShield 360 line focuses on corrosion resistance and service-ready brake component construction for everyday driving conditions.

This caliper includes the mounting bracket, caliper slides, dust boots, and a bleeder screw. The inlet uses a banjo bolt connection, and the unit is configured with M10-1.0 inlet threading and M10-1.25 bleeder threading. Part number 99P00961A is a direct-fit rear right brake caliper for Honda CR-V applications listed below.

This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

What It Helps Address

• Brake fluid leaks at the rear caliper
• Sticking or seized rear brake caliper movement
• Uneven rear brake pad wear
• Weak or inconsistent rear braking response
• Corrosion-related caliper replacement on a Honda CR-V

Installation Notes and Tips

Verify rear right placement before installation. Confirm banjo bolt fitment, inlet thread size, and bleeder screw thread size against the vehicle’s brake line and hydraulic connection. Transfer or replace brake pads and related service parts as needed, since pads are not included with this caliper. Bleed the brake system after installation to remove air from the hydraulic circuit.

Compatible With 2007-2012 Honda CR-V, rear right. Part number 99P00961A should be matched to the vehicle’s brake configuration and mounting bracket style before service begins.

Quality Assurance

Nugeon TechShield 360 brake components are built as remanufactured service parts for brake hydraulic replacement work. This caliper is supplied with the listed bracket, slides, dust boots, and bleeder screw configuration for the specified Honda CR-V fitment.