Nugeon 99P00961B Disc Brake Caliper - Rear Left

Rear Left Disc Brake Caliper for Honda CR-V

This Nugeon TechShield 360 disc brake caliper is a remanufactured rear left brake hydraulic replacement for 2007-2012 Honda CR-V models. Part number 99P00961B is built with a cast iron housing, grey rust-preventative finish, and included bracket for a direct-fit service repair.

Compatible with 2007-2012 Honda CR-V rear left applications, this caliper includes a steel piston, dust boots, bleeder screw, caliper slides, and hardware. The TechShield 360 product line focuses on corrosion resistance and service-ready brake hydraulic components for OE-style replacement work.

Key Features

• Remanufactured rear left disc brake caliper
• Fits 2007-2012 Honda CR-V, rear left
• Cast iron housing with rust-preventative grey finish
• Steel piston with 38 mm outside diameter
• Bracket included for the specified application
• Bleeder screw included with M10-1.25 x 25 thread
• Caliper slides, dust boots, and hardware included
• Banjo bolt inlet fitting with M10-1.0 inlet thread

Detailed Description

Nugeon 99P00961B is a rear left disc brake caliper for the 2007-2012 Honda CR-V, engineered as a remanufactured brake hydraulic replacement. It uses a cast iron body, a single steel piston, and a rust-preventative finish to support dependable brake service in the rear braking system. The included bracket and caliper slides simplify replacement of the original rear left assembly where the application calls for a bracketed caliper design.

TechShield 360 is Nugeon’s brake component line focused on corrosion protection and service-ready fitment details. For this Honda CR-V rear left application, the caliper is supplied with a bleeder screw, dust boots, and installation hardware, and it uses a banjo bolt inlet connection with M10-1.0 threading. Part number 99P00961B is a direct reference for shoppers searching for a rear left Honda CR-V brake caliper replacement.

What This Part Helps Address

• Leaking or seized rear brake caliper
• Uneven rear brake pad wear
• Brake drag at the rear wheel
• Corrosion on the caliper body or piston area
• Bleeding issues after brake hydraulic service

Installation Notes and Tips

Verify rear left fitment against the vehicle’s brake configuration before installation. Confirm the inlet thread size, bleeder thread size, and bracketed caliper layout match the original part on the 2007-2012 Honda CR-V. Transfer or replace brake pads as needed based on wear condition, and bleed the brake system after installation to remove air from the hydraulic circuit.

Because this caliper uses a banjo bolt inlet, inspect the copper crush washers and banjo connection surfaces during assembly. Check caliper slide movement and rotor condition before returning the vehicle to service. Part number 99P00961B is listed for the rear left position only.

Quality Assurance

Nugeon TechShield 360 brake components are remanufactured for brake hydraulic replacement applications and built with corrosion-resistant finishing details. This part number 99P00961B is specified for 2007-2012 Honda CR-V rear left fitment and is intended to match the listed OE-style mounting and connection requirements.