Nugeon 99P01017A Disc Brake Caliper - Rear Right

Rear Right Disc Brake Caliper for Honda and Acura

Nugeon TechShield 360 (tm) part 99P01017A is a remanufactured rear right disc brake caliper built for specific Honda and Acura applications. It is supplied with a mounting bracket and includes brake pad installation hardware, a banjo bolt, and copper crush washers where applicable.

Key Features

• Fits 2003-2011 Honda Element, rear right
• Fits 1999-2008 Acura TL, rear right
• Fits 2001-2003 Acura CL, rear right
• Remanufactured cast iron caliper with rust preventative finish
• Grey caliper housing with one 38 mm steel piston
• Includes bleeder screw, dust boots, caliper slides, and hardware
• Bracket included for the listed rear right applications
• Banjo bolt inlet fitting with M10-1.0 inlet thread size

Product Details

The Nugeon TechShield 360 (tm) line focuses on brake hydraulics components prepared for direct replacement service. Part 99P01017A is a rear right disc brake caliper with a single 1-inch (38 mm) steel piston, cast iron housing, and rust preventative coating. The unit uses an M10-1.25 bleeder screw thread and an M10-1.0 banjo bolt inlet connection, and it includes the bracket, slides, dust boots, and pad hardware specified for the application. This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

Common Brake Issues This Caliper Can Address

• Rear brake drag caused by a sticking caliper piston or slide hardware
• Uneven rear braking from a worn or corroded caliper assembly
• Brake fluid seepage at the caliper inlet or bleeder area
• Noisy or inconsistent rear brake operation from damaged caliper components
• Reduced braking performance on the rear right side of the vehicle

Installation Notes and Tips

Verify rear right placement before installation and confirm the banjo bolt connection, bleeder screw thread, and bracket style match the original setup. Transfer or replace brake pads as needed, then bleed the hydraulic system after installation to remove air from the line. Always inspect the brake hose, mounting points, and rotor condition before returning the vehicle to service.

Quality Assurance

Nugeon TechShield 360 (tm) remanufactured brake components are prepared for brake hydraulic replacement service with application-specific hardware and corrosion-resistant finishing details. Confirm vehicle fitment by year, make, model, and rear right position before ordering. Part number 99P01017A is listed for the applications shown above.