Nugeon 99P01017B Disc Brake Caliper - Rear Left

Rear Left Disc Brake Caliper for Honda, Acura

Nugeon TechShield 360 (tm) 99P01017B is a remanufactured rear left disc brake caliper built for direct replacement on select Honda and Acura applications. It is supplied with a mounting bracket and includes brake pad installation hardware, a banjo bolt, and copper crush washers where applicable.

Key Features

• Remanufactured disc brake caliper with grey rust preventative finish
• Cast iron housing with a single 38 mm steel piston
• Rear left position with bracket included
• Bleeder screw included; dust boots included
• Caliper slides included for service-ready installation
• Banjo bolt inlet fitting with M10-1.0 inlet thread size
• Caliper and pad hardware included; pads not included

TechShield 360 (tm) Product Line

Nugeon TechShield 360 (tm) focuses on remanufactured brake hydraulics with corrosion-resistant finishing and application-specific hardware details. For buyers searching for a rear left brake caliper for 2003-2011 Honda Element or 1999-2008 Acura TL, or a rear left caliper for 2001-2003 Acura CL, this part number 99P01017B matches the listed fitment and mounting style.

Detailed Description

Part number 99P01017B is a rear left disc brake caliper for 2003-2011 Honda Element, 1999-2008 Acura TL, and 2001-2003 Acura CL applications. The caliper uses a cast iron body, steel piston, and rust preventative finish to replace a worn or sticking original unit while maintaining the correct rear left mounting configuration. The included bracket, slides, dust boots, and bleeder screw support a complete hydraulic caliper replacement on the specified vehicles.

What This Part Helps Address

• Uneven rear braking caused by a sticking caliper piston
• Brake drag from seized or worn slide components
• Brake fluid seepage at a damaged bleeder or inlet connection
• Corrosion on the caliper body or piston area
• Poor pad contact from a worn rear left caliper assembly

Installation Notes and Tips

Verify rear left placement before installation and confirm the banjo bolt inlet connection matches the vehicle brake hose setup. Transfer or replace copper crush washers as required by the application, and bleed the brake system after installation to remove air from the hydraulic circuit. This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

Quality Assurance

Nugeon TechShield 360 (tm) remanufactured brake components are built for application-specific replacement use with the listed hardware and finish details. Confirm fitment against the vehicle year, make, model, and rear left position before ordering.