Nugeon 99P01162A Disc Brake Caliper - Front Left

Front Left Brake Caliper for Mazda 6

This Nugeon TechShield 360 remanufactured disc brake caliper is built for the front left position on 2003-2005 Mazda 6 models. Part number 99P01162A is a direct-fit brake hydraulics replacement with a 57 mm steel piston, supplied with a mounting bracket and brake pad installation hardware where applicable.

Key Features

• Fits 2003-2005 Mazda 6, front left
• Nugeon TechShield 360 product line for corrosion-focused brake protection
• Remanufactured cast iron caliper housing
• Grey rust preventative finish
• Includes bleeder screw, dust boots, caliper slides, and hardware
• Banjo bolt inlet fitting with M10-1.0 inlet thread
• Single 57 mm steel piston design
• Part number 99P01162A

Product Details

Built for the front left brake corner on the Mazda 6, this caliper uses a cast iron body with a rust preventative finish to support long-term service in brake hydraulic applications. The TechShield 360 line is Nugeon’s corrosion-protection product family, and this unit includes the core service components needed for caliper replacement, including the bleeder screw, dust boots, caliper slides, and bracket. Part number 99P01162A is a practical OE-style replacement for restoring hydraulic braking performance on 2003, 2004, and 2005 Mazda 6 vehicles.

This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

Common Problems This Part Addresses

• Sticking or seized front left caliper piston
• Brake fluid leakage at the caliper body or bleeder area
• Uneven front brake pad wear on the Mazda 6
• Reduced braking response from worn hydraulic components
• Corrosion-related caliper binding or slide issues

Installation Notes and Tips

Verify front left fitment before installation on 2003-2005 Mazda 6 models. Confirm the banjo bolt inlet connection, M10-1.0 inlet thread, and M8-1.0 bleeder thread match the vehicle’s brake line and service setup. Transfer or replace brake pads as needed, and bleed the brake system after installation to remove air from the hydraulic circuit.

Quality Assurance

Nugeon TechShield 360 focuses on corrosion-resistant brake component protection, and this remanufactured caliper is prepared for brake hydraulic service with a rust preventative finish and service-ready internal components. Part number 99P01162A is built for direct replacement use on the specified Mazda 6 front left application.