Nugeon 99P01337A Disc Brake Caliper - Rear Right

Rear Right Brake Caliper for Subaru Legacy and Outback

This Nugeon TechShield 360 remanufactured disc brake caliper is built for the rear right position on select 2006-2009 Subaru Legacy and Subaru Outback models. Part number 99P01337A is a direct-fit brake hydraulics replacement with a mounting bracket, making it a practical choice for restoring rear brake function on these applications.

Key Features

• Fits 2006-2009 Subaru Legacy, rear right
• Fits 2006-2009 Subaru Outback, rear right
• Remanufactured aluminum caliper with rust preventative finish
• Grey caliper housing with one 38 mm steel piston
• Includes bleeder screw, dust boots, caliper slides, and hardware
• Banjo bolt inlet fitting with M10-1.0 inlet thread size
• Supplied with mounting bracket for the listed applications
• TechShield 360 product line for corrosion-focused brake service

Detailed Description

Nugeon 99P01337A is a rear right disc brake caliper for 2006-2009 Subaru Legacy and 2006-2009 Subaru Outback models. It is remanufactured from aluminum and finished with a rust preventative coating to support long-term brake system service. The caliper uses a single 38 mm steel piston, includes a bleeder screw, dust boots, caliper slides, and hardware, and is configured with a banjo bolt inlet connection. The included bracket matches the listed fitment and helps simplify replacement on the rear brake assembly.

The TechShield 360 line focuses on corrosion resistance and brake-system durability for everyday driving conditions. If you are replacing a worn, sticking, or leaking rear brake caliper on a Subaru Legacy or Subaru Outback, part number 99P01337A provides the correct rear right configuration for the listed model years.

Common Reasons for Replacement

• Brake fluid leakage at the caliper body or bleeder area
• Uneven rear brake pad wear on the right side
• Sticking or seized caliper piston movement
• Corrosion on the caliper housing or slides
• Poor rear brake response or dragging brake symptoms

Installation Notes and Tips

Verify rear right placement before installation and confirm the banjo bolt connection, inlet thread size, and bleeder screw thread match the vehicle’s brake line setup. Transfer or replace brake pads as needed, and inspect the rotor, hose, and mounting surfaces for wear or contamination before completing the repair. After installation, bleed the brake system thoroughly to remove air from the hydraulic circuit.

Quality Assurance

This Nugeon brake caliper is remanufactured and finished with a rust preventative coating as part of the TechShield 360 line. Part number 99P01337A is built for the specified Subaru Legacy and Subaru Outback rear right applications and is intended to restore proper brake hydraulic operation in those vehicles.