Nugeon 99P01337B Disc Brake Caliper - Rear Left

Rear Left Disc Brake Caliper for Subaru Legacy and Outback

Nugeon TechShield 360 (tm) disc brake caliper Part Number 99P01337B is a remanufactured rear left brake hydraulic replacement for select 2006-2009 Subaru Legacy and 2006-2009 Subaru Outback models. It is built with a rust preventative finish, aluminum casting, and included bracket for a direct-fit repair on the rear left corner.

This caliper includes a bleeder screw, dust boots, caliper slides, and hardware, and it uses a banjo bolt inlet fitting with M10-1.0 thread sizing. The grey finish and TechShield 360 (tm) protection are suited for drivers replacing a worn or sticking rear brake caliper on Subaru Legacy and Subaru Outback applications.

Key Features

• Fits 2006-2009 Subaru Legacy, rear left
• Fits 2006-2009 Subaru Outback, rear left
• Remanufactured disc brake caliper with bracket included
• Aluminum housing with rust preventative finish
• Bleeder screw, dust boots, caliper slides, and hardware included
• Single-piston design with 38 mm piston diameter
• Banjo bolt inlet fitting with M10-1.0 inlet thread size
• Part Number: 99P01337B

Detailed Description

Nugeon 99P01337B is a rear left disc brake caliper for Subaru Legacy and Subaru Outback models from 2006 through 2009. The remanufactured unit is supplied with the mounting bracket and uses a single 38 mm steel piston inside an aluminum casting for rear brake service. TechShield 360 (tm) is the Nugeon product line used here to support corrosion resistance through a rust preventative caliper finish and protective dust boots.

The caliper is configured with a banjo bolt inlet and M10-1.0 thread sizing, and it includes a bleeder screw for brake bleeding during service. Part Number 99P01337B is a practical replacement when the original rear left caliper is seized, leaking, corroded, or no longer retracting properly on a Subaru Legacy or Subaru Outback.

What This Caliper Helps Fix

• Rear brake drag caused by a sticking caliper piston
• Brake fluid leakage at the caliper body or bleeder area
• Uneven rear pad wear on the left side
• Corrosion-related caliper seizure on Subaru Legacy and Subaru Outback vehicles
• Soft or inconsistent rear brake response from a worn hydraulic caliper

Installation Notes and Tips

Verify rear left position, inlet thread size, and banjo bolt connection before installation. Transfer or replace brake pads as needed, and inspect brake hoses, copper crush washers, and mounting surfaces during service. After installation, bleed the brake system thoroughly and confirm proper caliper movement before returning the vehicle to service.

Quality Assurance

This Nugeon TechShield 360 (tm) caliper is remanufactured for brake hydraulic replacement service and is built with a rust preventative finish, included dust boots, and a protective aluminum housing. Part Number 99P01337B is intended for direct replacement use on the listed Subaru Legacy and Subaru Outback rear left applications.