Nugeon 99P01340B Disc Brake Caliper - Rear Left

Rear Left Brake Caliper for Subaru Legacy and Outback

Nugeon TechShield 360 (tm) part number 99P01340B is a remanufactured rear left disc brake caliper for select 2010-2014 Subaru Legacy and 2010-2014 Subaru Outback models. It is built for direct replacement service with the correct bracket, bleeder screw, slides, dust boots, and rust-preventative finish.

For Subaru Legacy and Subaru Outback rear brake service, 99P01340B provides the key hydraulic and mounting components needed to restore caliper function. The TechShield 360 (tm) product line focuses on corrosion resistance and service-ready fitment for brake hydraulics applications.

Key Features

• Remanufactured disc brake caliper for the rear left position
• Fits 2010-2014 Subaru Legacy, rear left
• Fits 2010-2014 Subaru Outback, rear left
• Aluminum casting with grey rust-preventative finish
• Includes bracket, caliper slides, dust boots, hardware, and bleeder screw
• Single 38 mm steel piston
• Banjo bolt inlet fitting with M10-1.0 inlet thread
• Bleeder screw thread: M10-1.0 x 33

Detailed Description

This Nugeon brake caliper is engineered for rear left brake hydraulics service on the Subaru Legacy and Subaru Outback. The aluminum housing, steel piston, and rust-preventative finish support dependable brake operation in a direct-fit replacement format. Part number 99P01340B is specified with the correct bracket and caliper slides for the listed applications, helping maintain proper caliper alignment and pad movement.

TechShield 360 (tm) identifies Nugeon’s corrosion-focused product line for brake components exposed to road moisture, salt, and heat cycling. For 2010-2014 Subaru Legacy and 2010-2014 Subaru Outback rear brake repair, this caliper is a practical replacement when the original unit is seized, leaking, or no longer retracting correctly.

What This Part Helps Address

• Brake fluid leakage at the rear left caliper
• Sticking or seized caliper piston movement
• Uneven rear brake pad wear
• Poor brake pedal response caused by caliper hydraulic issues
• Corrosion on the original rear brake caliper assembly

Installation Notes and Tips

Verify rear left fitment before installation on the Subaru Legacy or Subaru Outback. Inspect the brake hose, banjo bolt sealing surfaces, pads, and rotor condition during service. Bleed the brake system after installation to remove air from the hydraulic circuit, and confirm that the caliper slides move freely before returning the vehicle to service.

Quality Assurance

Nugeon TechShield 360 (tm) brake components are remanufactured for replacement use and finished with rust-preventative protection. Part number 99P01340B is built for the listed Subaru Legacy and Subaru Outback rear left applications and includes the specified hydraulic and mounting features for service replacement.