Nugeon 99P01589A Disc Brake Caliper - Front Left

Front Left Disc Brake Caliper for Toyota and Lexus

Nugeon TechShield 360 (tm) part number 99P01589A is a remanufactured front left disc brake caliper built for specific Toyota and Lexus applications. It is supplied with a mounting bracket and uses a 60 mm steel piston, cast iron housing, and rust preventative finish for service-focused brake repair.

Compatible With 1997-2001 Toyota Camry, front left; 1998-2004 Toyota Avalon, front left; 1999-2003 Toyota Solara, front left; and 1997-2001 Lexus ES300, front left. The 99P01589A caliper is a direct-fit hydraulic replacement for vehicles using the listed inlet and bleeder specifications.

Key Features

• Remanufactured disc brake caliper for the front left position
• TechShield 360 (tm) product line for brake hydraulic service applications
• Cast iron housing with grey rust preventative finish
• 60 mm steel piston with one-piston design
• Bracket included for the specified applications
• Bleeder screw included
• Caliper slides and dust boots included
• Banjo bolt inlet fitting with M10-1.0 inlet thread size

Product Details

This Nugeon brake caliper is engineered for the front left side on select Toyota Camry, Toyota Avalon, Toyota Solara, and Lexus ES300 models. TechShield 360 (tm) identifies the product line used for brake hydraulic components with corrosion-resistant finishing and service-ready hardware details. Part number 99P01589A includes the bracket, slides, dust boots, and bleeder screw specified for the application, while the caliper body uses a cast iron housing and a steel piston for hydraulic braking operation.

This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

Common Brake Issues This Part Can Address

• Uneven braking from a sticking or seized front left caliper
• Brake fluid leakage at the caliper body or bleeder area
• Poor piston return caused by internal corrosion or wear
• Brake drag from damaged slides or dust boots
• Reduced braking performance from a worn hydraulic caliper assembly

Installation Notes and Tips

Verify the vehicle’s front left brake configuration, inlet thread size, and banjo bolt connection before installation. Transfer or replace brake pads as needed, and inspect the brake hose, copper crush washers, and mounting points for wear or damage. After installation, bleed the brake system thoroughly and confirm proper pedal feel and caliper movement.

Quality Assurance

Nugeon remanufactured brake components are processed for brake service applications with attention to fitment, corrosion protection, and hydraulic function. Confirm the part number 99P01589A against the vehicle application before ordering.