Nugeon 99P01653A Disc Brake Caliper - Rear Right

Rear Right Disc Brake Caliper for Toyota and Lexus

Nugeon TechShield 360 (tm) part number 99P01653A is a remanufactured rear right disc brake caliper built for select Toyota and Lexus applications. It is supplied with a mounting bracket and is configured for vehicles that use a banjo bolt inlet and a single 48 mm steel piston.

Key Features

• Remanufactured cast iron disc brake caliper with rust preventative finish
• Rear right position for select Toyota 4Runner, Lexus GX460, Lexus GX470, and Toyota Sequoia applications
• Includes bracket, bleeder screw, caliper slides, dust boots, and general hardware
• Banjo bolt inlet fitting with M10-1.0 inlet thread size
• Bleeder screw thread size: M10-1.0; bleeder screw thread length: M10-1.0 x 33
• Single 48 mm steel piston for hydraulic brake actuation
• Grey caliper color with TechShield 360 (tm) protection

Product Details

TechShield 360 (tm) is Nugeon’s product line for remanufactured brake hydraulics with corrosion-focused finishing and application-specific hardware configuration. This caliper is built for rear right brake service on 2010-2024 Toyota 4Runner, 2010-2023 Lexus GX460, 2003-2009 Lexus GX470, and 2001-2007 Toyota Sequoia models. Part number 99P01653A is a direct service replacement for vehicles that use the listed bracketed rear caliper design.

This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

What This Caliper Helps Address

• Brake drag or uneven rear braking caused by a sticking caliper piston
• Brake fluid leakage at the caliper body, bleeder, or inlet connection
• Corrosion-related caliper seizure on rear disc brake systems
• Poor pad movement from worn slides or damaged dust boots
• Brake pull or inconsistent rear brake response on the right side

Installation Notes and Tips

Verify rear right fitment before installation on your Toyota 4Runner, Lexus GX460, Lexus GX470, or Toyota Sequoia. Confirm the banjo bolt inlet, M10-1.0 thread size, and bracketed caliper layout match the original unit. Transfer or replace brake pads as needed, and bleed the hydraulic system after installation to remove air from the brake circuit.

Quality Assurance

Nugeon remanufactures this caliper with a cast iron housing, steel piston, dust boots, and rust preventative finish to support brake system service on the specified applications. TechShield 360 (tm) identifies the product line used for this remanufactured brake hydraulics component.