Nugeon 99P01658A Disc Brake Caliper - Rear Right

Rear Right Brake Caliper for Toyota Avalon

This Nugeon TechShield 360 disc brake caliper is a remanufactured rear right replacement for select 2000-2004 Toyota Avalon models. Part number 99P01658A is built around a cast iron housing with a grey rust-preventative finish, making it a direct service option for brake hydraulic repairs on the Toyota Avalon rear brake system.

Key Features

• Fits 2000-2004 Toyota Avalon, rear right
• Remanufactured disc brake caliper with bracket included
• Cast iron housing with rust-preventative grey finish
• Includes bleeder screw, dust boots, and caliper slides
• Banjo bolt inlet fitting with M10-1.0 inlet thread size
• 38 mm steel piston with M7-1.0 bleeder thread
• TechShield 360 product line for brake hydraulic service

Detailed Description

Nugeon 99P01658A is a rear right disc brake caliper for the 2000-2004 Toyota Avalon, supplied with the mounting bracket for the listed application. The TechShield 360 line focuses on brake hydraulic components with corrosion-resistant finishing and service-ready hardware details, and this unit includes a bleeder screw, dust boots, caliper slides, and general hardware where applicable. The caliper uses a single 38 mm steel piston and a banjo bolt inlet connection for the specified Toyota Avalon rear brake setup.

This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application. Part number 99P01658A is a practical replacement choice when servicing rear brake caliper wear, leakage, or sticking on a Toyota Avalon.

What This Caliper Helps Address

• Brake fluid leakage at the rear right caliper
• Uneven rear braking on 2000-2004 Toyota Avalon models
• Sticking or seized caliper piston movement
• Corrosion on the caliper housing or bleeder area
• Brake drag caused by worn internal seals or slides

Installation Notes and Tips

Verify rear right fitment before installation on the 2000-2004 Toyota Avalon. Confirm the banjo bolt connection, inlet thread size, and bleeder screw thread size match the vehicle’s brake line and service requirements. Transfer or replace brake pads and related wear items as needed, and bleed the brake system thoroughly after installation to remove air from the hydraulic circuit.

Quality Assurance

This Nugeon remanufactured caliper is built for brake hydraulic service with a rust-preventative finish, cast iron housing, dust boots, and a service bleeder screw. TechShield 360 identifies the product line used for this brake component.