Nugeon 99P01663A Disc Brake Caliper - Rear Right

Rear Right Brake Caliper for Toyota Highlander

This Nugeon TechShield 360 disc brake caliper is a remanufactured rear right replacement for select 2001-2003 Toyota Highlander models. It is built with a cast iron housing, grey rust-preventative finish, and a 38 mm steel piston for brake hydraulic service on the rear passenger side.

Key Features

• Fits 2001-2003 Toyota Highlander, rear right
• Nugeon TechShield 360 product line for brake hydraulic replacement applications
• Remanufactured disc brake caliper with bracket included
• Cast iron housing with grey rust-preventative finish
• 38 mm steel piston with dust boots included
• Bleeder screw included; banjo bolt inlet fitting
• Caliper slides included for bracketed rear installation
• Part number 99P01663A for application matching

Detailed Description

Nugeon 99P01663A is a rear right disc brake caliper for the 2001-2003 Toyota Highlander. The TechShield 360 line focuses on brake hydraulic components with corrosion-resistant finishing and service-ready hardware details, making this caliper a direct replacement option for rear brake repair work on the Highlander platform. The unit includes the mounting bracket, slides, dust boots, and bleeder screw, and it uses a M10-1.0 inlet thread with banjo bolt connection for the specified application.

This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

Common Problems This Part Addresses

• Rear brake drag caused by a sticking caliper piston
• Brake fluid leakage at the caliper body or bleeder area
• Uneven rear braking on the Toyota Highlander
• Corrosion-related caliper seizure on older brake systems
• Noise or poor pedal response from a worn hydraulic caliper assembly

Installation Notes and Tips

Fits 2001-2003 Toyota Highlander, rear right. Confirm the rear passenger-side position before installation and verify the banjo bolt connection, M10-1.0 inlet thread, and M7-1.0 bleeder thread match the vehicle’s brake line and service setup. Transfer or replace brake pads and related wear items as needed, since pads are not included. Bleed the brake system after installation and inspect for leaks at the inlet and bleeder screw.

Quality Assurance

As part of Nugeon’s TechShield 360 line, this remanufactured caliper is finished with rust-preventative protection and assembled for brake hydraulic service on the specified Toyota Highlander applications. Part number 99P01663A is intended for direct application matching on the listed rear right fitment.