Nugeon 99P01700B Disc Brake Caliper - Rear Left

Rear Left Brake Caliper for Toyota Tundra and Sequoia

This Nugeon TechShield 360 disc brake caliper is a remanufactured rear left replacement for select Toyota Tundra and Toyota Sequoia applications. Part number 99P01700B is built with a cast iron housing, a grey rust-preventative finish, and included bracket, slides, dust boots, bleeder screw, and brake pad installation hardware where applicable.

Key Features

• Fits 2007-2015 Toyota Tundra, rear left
• Fits 2008-2015 Toyota Sequoia, rear left
• Nugeon TechShield 360 product line for brake hydraulics applications
• Remanufactured disc brake caliper with bracket included
• Cast iron housing with rust-preventative finish
• Includes caliper slides, dust boots, bleeder screw, and hardware
• Banjo bolt inlet fitting with M10-1.0 inlet thread size
• Single 48 mm steel piston

Product Details

The Nugeon 99P01700B is a rear left disc brake caliper engineered for Toyota Tundra and Toyota Sequoia brake service. It uses a 48 mm steel piston, a banjo bolt inlet, and an M7-1.0 bleeder screw thread size. The TechShield 360 line focuses on brake hydraulic components with corrosion-resistant finishing and service-ready hardware details for direct replacement use. Part number 99P01700B is a practical choice when replacing a worn or sticking rear caliper on these Toyota trucks and SUVs.

This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

Common Problems This Part Can Address

• Rear brake drag caused by a sticking caliper piston
• Uneven braking on the left rear wheel
• Brake fluid seepage at the caliper or bleeder area
• Corrosion on the caliper body or slides
• Reduced pad movement from worn hydraulic components

Installation Notes and Tips

Verify rear left fitment before installation on 2007-2015 Toyota Tundra and 2008-2015 Toyota Sequoia models. Confirm the banjo bolt connection, inlet thread size, and bleeder screw thread size match the vehicle’s brake line and hydraulic setup. Transfer or replace brake pads as needed, and bleed the brake system after installation to remove air from the hydraulic circuit.

Quality Assurance

Built as a remanufactured brake caliper in Nugeon’s TechShield 360 line, this unit is finished for rust prevention and supplied with key service components for brake system replacement. The cast iron housing, steel piston, and included bracket support a direct-fit repair for the listed Toyota applications.