Nugeon 99P01710B Disc Brake Caliper - Front Right

Front Right Disc Brake Caliper for Toyota, Scion, Pontiac

Nugeon TechShield 360 (tm) disc brake caliper Part Number 99P01710B is a remanufactured front right caliper built for specific Toyota, Scion, and Pontiac applications. It includes the mounting bracket and brake pad installation hardware where applicable, along with a rust-preventative finish for service-ready replacement.

Key Features

• Remanufactured cast iron disc brake caliper with grey finish
• Front right position with supplied mounting bracket
• 60 mm steel piston for hydraulic braking force
• Bleeder screw included with M7-1.0 thread
• Banjo bolt inlet fitting with M10-1.0 inlet thread
• Caliper slides, dust boots, and hardware included
• Brake pad installation hardware included where applicable
• Part Number 99P01710B from Nugeon TechShield 360 (tm)

Product Details

This Nugeon TechShield 360 (tm) brake caliper is built for the front right side and uses a single 60 mm steel piston in a cast iron housing. The unit is finished with rust preventative coating and includes the bracket, slides, dust boots, bleeder screw, and caliper and pad hardware. It is a direct replacement style part for 2009-2019 Toyota Corolla front right, 2009-2014 Toyota Matrix front right, 2008-2014 Scion xD front right, and 2009-2010 Pontiac Vibe front right applications. Part Number 99P01710B is a practical choice when replacing a worn or sticking front brake caliper on these vehicles.

TechShield 360 (tm) identifies Nugeon’s product line for corrosion-focused brake service parts, with attention to protective finishing and included service components for a cleaner replacement process.

Common Problems This Part Can Address

• Uneven front brake pad wear on the right side
• Brake drag caused by a sticking piston or slide hardware
• Brake fluid seepage at the caliper body or bleeder area
• Reduced braking response from a worn hydraulic caliper assembly
• Corrosion-related caliper replacement on high-mileage vehicles

Installation Notes and Tips

Verify front right fitment before installation and confirm the banjo bolt and inlet thread sizes match the vehicle’s brake hose connection. Transfer or replace brake pads as needed, and bleed the brake system after installation to remove air from the hydraulic circuit. Inspect the rotor, hose, and mounting points for wear or damage before returning the vehicle to service. Fits 2009-2019 Toyota Corolla, front right. Fits 2009-2014 Toyota Matrix, front right. Fits 2008-2014 Scion xD, front right. Fits 2009-2010 Pontiac Vibe, front right.

Quality Assurance

This remanufactured caliper is built with a cast iron housing, steel piston, protective finish, and included service hardware to support consistent brake system restoration. Part Number 99P01710B is specified for the listed front right applications and should be matched to the vehicle’s original brake configuration before installation.