Nugeon 99P01817B Disc Brake Caliper - Front Right

Front Right Brake Caliper for Kia Sedona

This Nugeon TechShield 360 brake caliper is a remanufactured front right disc brake caliper for 2002-2004 Kia Sedona applications. Built with a cast iron housing, steel pistons, and a rust preventative finish, part number 99P01817B is made for direct replacement service on the front right corner.

TechShield 360 is Nugeon’s product line focused on corrosion resistance and service-ready brake hydraulics. For buyers searching for a 2002-2004 Kia Sedona front right brake caliper, 99P01817B provides the key OE-style features needed for a proper hydraulic brake repair.

Key Features

• Fits 2002-2004 Kia Sedona, front right
• Remanufactured disc brake caliper with bracket included
• Cast iron housing with rust preventative finish
• Grey caliper color with steel pistons
• Bleeder screw included
• Caliper slides included
• Dust boots included
• Banjo bolt inlet fitting
• Housing cast numbers: BC140067, R
• Part number 99P01817B

Detailed Description

Nugeon 99P01817B is a front right brake caliper for the 2002-2004 Kia Sedona, supplied with the mounting bracket for a direct hydraulic brake replacement. It uses a 45 mm piston design, M10-1.0 inlet and bleeder threads, and a banjo bolt inlet connection to match the original brake system layout. The TechShield 360 finish adds rust prevention for long-term service in demanding driving conditions.

This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application. If you are replacing a worn or sticking front right caliper on a Kia Sedona, 99P01817B is built to restore normal brake operation with the correct fitment and hardware configuration.

What It Is Used For

• Replacing a leaking front right brake caliper on a Kia Sedona
• Correcting uneven braking caused by a sticking caliper piston
• Restoring brake pedal response after caliper corrosion or seizure
• Addressing brake drag, pull, or pad wear issues at the front right wheel
• Repairing damaged bleeder or inlet connection components

Installation Notes and Tips

Verify front right fitment before installation and confirm the banjo bolt connection, M10-1.0 thread sizes, and bracket style match the vehicle. Transfer or replace brake pads as needed, and use new copper crush washers where applicable when connecting the brake hose. Bleed the brake system thoroughly after installation to remove air from the hydraulic circuit.

Quality Assurance

Nugeon remanufactures brake hydraulics for direct replacement service, and the TechShield 360 line adds a rust preventative finish to support corrosion resistance in brake system applications. Part number 99P01817B is built for the specified 2002-2004 Kia Sedona front right application.