Nugeon 99P02212A Disc Brake Caliper - Front Right

Nugeon Front Right Disc Brake Caliper

The Nugeon TechShield 360 (tm) disc brake caliper, part number 99P02212A, is a front right brake hydraulics replacement for select Audi applications. It is built with an aluminum caliper casting, a single aluminum piston, and an e-coat finish for a service-ready OE-style fit.

Compatible with Audi A6, Audi A6 Quattro, and Audi A7 Quattro front right brake positions, this caliper includes the bracket, slides, bleeder screw, dust boots, and caliper-and-pad hardware. Pads are not included.

Key Features

• Front right disc brake caliper for select Audi models
• Aluminum caliper casting with gray e-coat finish
• Single 60 mm aluminum piston
• Bracket included for the listed applications
• Bleeder screw, bleeder cap, caliper slides, and dust boots included
• Brake pad installation hardware included where applicable
• Inlet fitting type: line; inlet thread size: M10-1.0
• Caliper manufacturer listed as TRW
• FMVSS pad number D1322 reference

TechShield 360 (tm) Details

Nugeon TechShield 360 (tm) identifies this caliper as part of a protected brake component line focused on corrosion resistance and service durability. For Audi A6, Audi A6 Quattro, and Audi A7 Quattro front right brake service, part number 99P02212A provides the core hydraulic caliper assembly with the mounting bracket and service hardware needed for the listed fitments.

What This Caliper Helps Address

• Sticking or seized front right caliper operation
• Brake fluid leakage at the caliper body or bleeder area
• Uneven braking caused by worn piston or slide components
• Corrosion on the caliper housing or bracket
• Brake drag from damaged dust boots or slide hardware

Installation Notes

Fits 2014-2018 Audi A6, front right. Fits 2014-2017 Audi A6 Quattro, front right. Fits 2014-2015 Audi A7 Quattro, front right. Fits 2016-2018 Audi A7 Quattro, front right. Fits 2012 Audi A6 Quattro, front right.

Verify the inlet thread size, bleeder size, and bracket configuration before installation. Pads are not included, so inspect pad condition and replace as needed during brake service. Bleeding the hydraulic system after installation is required.

Quality Assurance

This caliper uses an aluminum housing, aluminum piston, dust boots, and an e-coat finish to support consistent brake service on the listed Audi applications. The OE manufacturer listed for this caliper is TRW, and the part number 99P02212A is specified for the front right position on the vehicles shown above.