Nugeon 99P09325B Disc Brake Caliper - Rear Right

Rear Right Brake Caliper for Volvo

This Nugeon TechShield 360 disc brake caliper is a remanufactured rear right replacement for select Volvo applications. Part number 99P09325B is built with a cast iron housing, grey rust-preventative finish, and a 42 mm steel piston for direct brake hydraulic service on the listed vehicles.

Key Features

• Fits select 1999-2009 Volvo rear right brake applications
• Remanufactured disc brake caliper with bracket included
• Cast iron housing with rust-preventative grey finish
• 42 mm steel piston for hydraulic braking operation
• Bleeder screw included; dust boots and caliper slides included
• M10-1.0 inlet and bleeder thread sizes
• Bracket cast number 474; housing cast numbers 980, 9434166, RH

TechShield 360 Product Line

Nugeon TechShield 360 focuses on remanufactured brake hydraulics with attention to corrosion resistance and service-ready fitment details. For this Volvo rear right caliper, the product line includes a rust-preventative finish, supplied bracket, and key hydraulic components needed for brake system restoration.

Detailed Description

Part number 99P09325B is a rear right disc brake caliper for 1999-2006 Volvo S80, 2001-2009 Volvo S60, 2001-2007 Volvo V70, and 2003-2007 Volvo XC70. It is supplied with the mounting bracket and uses a single 42 mm steel piston in a cast iron body for brake pressure transfer at the rear wheel. The caliper includes a bleeder screw, dust boots, caliper slides, and hardware, with an M10-1.0 inlet port and M10-1.0 bleeder thread size. This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

Common Brake Issues It Addresses

• Rear brake drag caused by a sticking caliper piston or slide
• Uneven braking from a worn or corroded caliper assembly
• Brake fluid seepage at the caliper body or bleeder area
• Reduced rear braking performance on Volvo S60, V70, XC70, or S80 models
• Noise or pull related to a failing rear right hydraulic caliper

Installation Notes and Tips

Verify rear right position, bracket style, and inlet/bleeder thread sizes before installation. Transfer or replace brake pads as needed, and bleed the hydraulic system after installation to remove air from the circuit. Confirm the banjo bolt and copper crush washer setup where applicable, and inspect the brake hose, rotor, and pad hardware for wear before returning the vehicle to service.

Quality Assurance

Nugeon remanufactures this caliper for brake hydraulic replacement service and includes corrosion-resistant finishing details, replacement seals, and service hardware components listed in the product data. Part number 99P09325B is built for the specified Volvo rear right applications.