Nugeon 99P17275A Disc Brake Caliper - Front Left

Front Left Brake Caliper for Saturn SC1, SC2, SL, SL1, SL2, SW1, SW2

Nugeon TechShield 360 (tm) part number 99P17275A is a remanufactured front left disc brake caliper built for Saturn compact cars with the correct bracketed application. It is specified for 1991-2002 Saturn SL, SL1, SL2, 1991-1992 Saturn SC, 1993-2002 Saturn SC1 and SC2, and 1993-2001 Saturn SW2 and SW1 front left positions.

The TechShield 360 (tm) line focuses on corrosion resistance and service-ready brake hydraulics. This caliper uses a cast iron housing, steel piston, rust preventative finish, and included dust boots and slides to support consistent brake operation on Saturn SC1, Saturn SL2, and related front left applications.

• Remanufactured disc brake caliper for the front left position
• Supplied with mounting bracket for the listed Saturn applications
• Cast iron housing with grey rust preventative finish
• Steel piston with 51 mm / 2 in outside diameter
• Bleeder screw included; banjo bolt inlet fitting
• Caliper slides, dust boots, and hardware included
• Inlet thread size: M10-1.5; bleeder thread size: M10-1.0

Detailed Product Information

Part number 99P17275A is a front left brake caliper assembly for Saturn SC1, SC2, SL, SL1, SL2, SW1, and SW2 models within the listed year ranges. It is a remanufactured unit with the bracket included, making it a direct replacement for the specified brake hydraulics application. The caliper uses a single 51 mm steel piston and a banjo bolt inlet connection, with the bleeder screw already installed.

For buyers searching for a Saturn SL front left brake caliper, Saturn SC2 front left caliper, or a Saturn SW1 brake caliper replacement, this Nugeon TechShield 360 (tm) unit matches the confirmed fitment data and key hydraulic specifications. Part number 99P17275A is also identified by housing cast numbers AD51V, 2047, 38670, and L.

Common Brake Issues This Caliper Addresses

• Leaking or seized front left caliper housing
• Uneven braking caused by piston or slide wear
• Corrosion on the caliper body or bleeder area
• Brake drag from sticking hydraulic components
• Loss of braking performance at the front left wheel

Installation Notes and Tips

Verify the front left position, inlet thread size, and banjo bolt connection before installation. Transfer or replace brake pads as needed, and inspect the brake hose, copper crush washers, and mounting surfaces during service. Bleed the brake system after installation to remove air and restore proper pedal feel.

Because this caliper is supplied with a bracket, confirm that the existing brake setup matches the bracketed application for your Saturn SC1, Saturn SL, or Saturn SW2 before ordering. Part number 99P17275A should be matched to the vehicle year, model, and front left position exactly as listed.

Quality Assurance

Nugeon TechShield 360 (tm) remanufactured brake components are built for brake hydraulic replacement applications with corrosion-resistant finishing and service-ready hardware details. This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.