Nugeon 99P17275B Disc Brake Caliper - Front Right

Front Right Disc Brake Caliper for Saturn SC1, SC2, SL, SL1, SL2, SW1, SW2

Nugeon TechShield 360 (tm) 99P17275B is a remanufactured front right disc brake caliper built for select Saturn compact cars and wagons from 1991-2002. It is supplied with a mounting bracket and uses a 2-inch steel piston, cast iron housing, and rust preventative finish for service-ready brake hydraulics replacement.

The TechShield 360 (tm) product line focuses on corrosion resistance and dependable brake hardware fitment for everyday repair work. For Saturn SC1, SC2, SL, SL1, SL2, SW1, and SW2 applications, this caliper is built to match the front right position and the original brake connection style.

• Fits 1993-2002 Saturn SC1, front right
• Fits 1993-2002 Saturn SC2, front right
• Fits 1991-2002 Saturn SL, front right
• Fits 1991-2002 Saturn SL1, front right
• Fits 1991-2002 Saturn SL2, front right
• Fits 1993-2001 Saturn SW2, front right
• Fits 1993-1999 Saturn SW1, front right
• Fits 1991-1992 Saturn SC, front right
• Remanufactured disc brake caliper with bracket included
• Grey cast iron housing with rust preventative finish
• Single 51 mm steel piston
• Bleeder screw included; dust boots and caliper slides included
• Banjo bolt inlet with M10-1.5 inlet thread size

Brake Replacement Details

Nugeon 99P17275B is a direct-fit front right brake caliper for Saturn SC1, SC2, SL, SL1, SL2, SW1, and SW2 models listed above. It uses a banjo bolt inlet fitting, M10-1.5 inlet thread size, and an M10-1.0 bleeder screw thread, making it a practical replacement when the original caliper is leaking, sticking, or no longer holding consistent hydraulic pressure. This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

Common Problems This Caliper Can Address

• Brake fluid leakage at the caliper body or bleeder screw area
• Uneven front brake performance on the right side
• Sticking or seized caliper piston movement
• Corrosion on the original caliper housing or slides
• Brake drag caused by worn internal seals or damaged dust boots

Installation Notes and Tips

Confirm the vehicle is a front right application before installation. Transfer or replace the brake pads as needed, and inspect the rotor, brake hose, and mounting surfaces for wear or damage. Bleed the brake system after installation to remove air from the hydraulic circuit, and verify that the banjo bolt connection and bleeder screw are properly tightened to specification.

Quality Assurance

This remanufactured Nugeon brake caliper is built with a cast iron housing, steel piston, included hardware, dust boots, and slides to support consistent brake service on the listed Saturn applications. The TechShield 360 (tm) finish adds rust prevention for long-term brake system durability.