Nugeon 99P17300B Disc Brake Caliper - Rear Right

Rear Right Disc Brake Caliper for GM Applications

This Nugeon TechShield 360 disc brake caliper is a remanufactured rear right replacement built for select Chevrolet, Buick, Pontiac, and Oldsmobile vehicles. Part number 99P17300B is specified for brake hydraulic service where a direct-fit rear caliper with bracket is required.

Compatible with applications such as the Chevrolet Impala, Buick LaCrosse, and Pontiac Grand Prix, this caliper is built around a cast iron housing with a grey rust-preventative finish. The TechShield 360 product line focuses on corrosion resistance and service-ready brake hydraulic components for everyday repair work.

Key Features

• Remanufactured disc brake caliper for rear right placement
• Supplied with mounting bracket
• Cast iron housing with rust-preventative finish
• Single 38 mm steel piston
• Bleeder screw included
• Caliper slides and dust boots included
• Banjo bolt inlet fitting with M10-1.5 inlet thread
• Brake pad installation hardware and copper crush washers included where applicable
• Part number 99P17300B

Detailed Description

Nugeon 99P17300B is a rear right disc brake caliper engineered for select GM mid-size and full-size passenger cars. It uses a 38 mm steel piston, cast iron housing, and a rust-preventative coating to support brake service in corrosion-prone environments. The included bracket, bleeder screw, slides, and dust boots help match the original brake layout on supported vehicles.

This caliper is listed for 2000-2010 Chevrolet Impala rear right, 2008-2009 Buick Allure rear right, 2008-2009 Buick LaCrosse rear right, 2000-2007 Chevrolet Monte Carlo rear right, 2003-2005 Buick Century rear right, 1997-2004 Buick Regal rear right, 1997-2003 Pontiac Grand Prix rear right, and 1998-2002 Oldsmobile Intrigue rear right. Use part number 99P17300B when verifying the correct rear right brake caliper for these applications.

Common Repair Uses

• Restores rear brake hydraulic pressure after caliper wear or seizure
• Replaces a leaking or sticking rear right caliper
• Addresses uneven rear brake pad wear
• Helps correct brake drag caused by damaged slides or piston corrosion
• Supports brake service on Chevrolet Impala, Buick LaCrosse, and Pontiac Grand Prix rear right applications

Installation Notes

Confirm rear right position, inlet thread size, and banjo bolt connection before installation. Transfer or replace brake pads as needed, and inspect the brake hose, rotor, and mounting points for wear or damage. Bleed the brake system after installation to remove air from the hydraulic circuit. Verify that the caliper bracket and slide hardware move freely before returning the vehicle to service.

Quality Assurance

This remanufactured Nugeon caliper is built for brake hydraulic replacement service and finished with corrosion-resistant protection. TechShield 360 is Nugeon’s product line for brake components with added attention to rust prevention and service durability.