Nugeon 99P17302A Disc Brake Caliper - Front Right

Nugeon TechShield 360 Disc Brake Caliper

The Nugeon TechShield 360 disc brake caliper, part number 99P17302A, is a remanufactured front right caliper built for direct replacement on select GM and Isuzu applications. It features a cast iron housing, dual steel pistons, a supplied mounting bracket, and a rust preventative finish for service-ready brake hydraulics.

Compatible with 1998-2005 Chevrolet Blazer, front right; 1998-2005 GMC Jimmy, front right; 1998-2004 Chevrolet S10, front right; 1998-2004 GMC Sonoma, front right; 1998-2001 Oldsmobile Bravada, front right; and 1998-2000 Isuzu Hombre, front right.

Key Features

• Remanufactured disc brake caliper for front right brake service
• TechShield 360 product line with rust preventative finish
• Cast iron housing with grey finish
• Two steel pistons, 46 mm (2 in.) outside diameter
• Bleeder screw included with M10-1.5 thread
• Bracket included for the listed applications
• Caliper slides and dust boots included
• Banjo bolt inlet fitting with M10-1.5 inlet thread
• Package contents include brake pad installation hardware, banjo bolt, and copper crush washers where applicable

Product Details

Nugeon 99P17302A is a remanufactured front right disc brake caliper for Chevrolet Blazer, GMC Jimmy, Chevrolet S10, GMC Sonoma, Oldsmobile Bravada, and Isuzu Hombre models listed above. The TechShield 360 line focuses on corrosion-resistant service parts, and this caliper uses a rust preventative coating, steel pistons, and a cast iron body to restore hydraulic clamping performance at the wheel. The supplied bracket, slides, dust boots, and bleeder screw support a complete brake service on the specified applications.

This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

Common Brake Issues This Caliper Can Address

• Uneven braking caused by a sticking or seized front right caliper
• Brake pull from worn piston seals or corroded caliper hardware
• Soft or inconsistent pedal response related to hydraulic leakage at the caliper
• Uneven pad wear from restricted caliper slide movement
• Reduced braking performance from a damaged or worn original caliper assembly

Installation Notes and Tips

• Verify front right position and match the inlet fitting and bleeder thread specifications before installation.
• Inspect brake hoses, pads, rotors, and mounting surfaces during caliper replacement.
• Bleed the brake system after installation to remove air from the hydraulic circuit.
• Confirm bracket and slide alignment during assembly for proper pad movement.
• Use the correct banjo bolt and copper crush washers where applicable.

Quality Assurance

This Nugeon TechShield 360 caliper is remanufactured to restore brake function with application-specific fitment for the listed Chevrolet, GMC, Oldsmobile, and Isuzu models. Part number 99P17302A is built with a cast iron housing, steel pistons, dust boots, and corrosion-resistant finishing details to support dependable brake service.