Nugeon 99P17339A Disc Brake Caliper - Front Left

Front Left Disc Brake Caliper for Equinox and Vue

Nugeon TechShield 360 (tm) 99P17339A is a remanufactured front left disc brake caliper built for specific Chevrolet and Saturn applications. It features a cast iron housing, phenolic pistons, a rust preventative finish, and included bracket, slides, dust boots, and bleeder screw for a direct brake hydraulic service replacement.

Key Features

• Fits 2005 Chevrolet Equinox, front left, with mounting bracket and casting number 202105
• Fits 2002-2003 Saturn Vue, front left, with mounting bracket
• Remanufactured disc brake caliper from Nugeon TechShield 360 (tm)
• Cast iron caliper body with grey rust preventative finish
• Phenolic piston design with 42 mm piston diameter
• Bleeder screw included with M10-1.0 thread
• Banjo bolt inlet fitting with M10-1.5 inlet thread
• Caliper slides, dust boots, and hardware included

Detailed Description

This Nugeon 99P17339A front left disc brake caliper is built for brake hydraulic replacement on the 2005 Chevrolet Equinox and 2002-2003 Saturn Vue. The TechShield 360 (tm) product line focuses on corrosion-resistant service parts, and this caliper uses a rust preventative finish, cast iron housing, and phenolic pistons to support consistent brake operation in the specified applications. The unit includes the bracket, slides, dust boots, and bleeder screw, and it uses a banjo bolt inlet connection with M10-1.5 inlet threading.

This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application. Use part number 99P17339A when matching the correct front left caliper for your Chevrolet Equinox or Saturn Vue brake repair.

Common Problems This Part Addresses

• Sticking or seized front left caliper movement
• Brake fluid leakage at the caliper or bleeder area
• Uneven front brake pad wear on the driver side
• Corrosion-related caliper replacement needs
• Brake drag or reduced braking response from worn hydraulic components

Installation Notes and Tips

Verify front left position, bracket style, inlet thread size, and casting number before installation. Confirm the banjo bolt connection and bleeder screw thread match the vehicle brake line and service setup. Transfer or install brake pads separately, since pads are not included. After installation, bleed the brake system thoroughly and inspect for leaks at the inlet fitting and bleeder screw.

Quality Assurance

Nugeon TechShield 360 (tm) remanufactured brake components are built for application-specific fitment and service replacement. Part number 99P17339A is listed for the confirmed Chevrolet Equinox and Saturn Vue front left applications shown above.