Nugeon 99P17353B Disc Brake Caliper - Front Right

Front Right Disc Brake Caliper for Select GM SUVs

Nugeon TechShield 360 (tm) part number 99P17353B is a remanufactured front right disc brake caliper built for select Buick, Chevrolet, GMC, Isuzu, and Saab applications. It features an aluminum housing, dual phenolic pistons, and a rust preventative finish for a direct-fit brake hydraulics replacement.

Key Features

• Remanufactured disc brake caliper with TechShield 360 (tm) protection
• Front right position with mounting bracket included
• Aluminum casting with grey rust preventative finish
• Dual 45 mm phenolic pistons for consistent hydraulic actuation
• Bleeder screw included with M10-1.0 thread
• Caliper slides, dust boots, and brake pad installation hardware included
• Banjo bolt inlet fitting with copper crush washers where applicable
• Part number 99P17353B for catalog and fitment lookup

Product Details

This Nugeon TechShield 360 (tm) disc brake caliper is engineered for front right brake service on 2002-2005 Chevrolet Trailblazer EXT, 2002-2005 GMC Envoy XL, 2003-2005 Chevrolet SSR, 2003-2005 Isuzu Ascender, 2004-2005 Buick Rainier, 2004-2005 GMC Envoy XUV, 2005 GMC Envoy, and 2005 Saab 9-7x. The remanufactured design restores hydraulic clamping force while the phenolic pistons help reduce heat transfer at the wheel end. Part number 99P17353B is a practical replacement when servicing a worn or sticking front right caliper on these platforms.

TechShield 360 (tm) identifies Nugeon’s protected caliper line, focused on corrosion resistance and service-ready components for brake hydraulics repair. This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

Common Brake Issues This Caliper Can Address

• Uneven front brake pad wear on the right side
• Brake drag caused by a sticking caliper piston or slide
• Reduced braking response from a leaking or worn hydraulic caliper
• Corrosion-related caliper seizure in rust-prone climates
• Noise or vibration caused by worn caliper hardware or damaged boots

Installation Notes

• Verify front right position and confirm banjo bolt inlet and M10-1.0 thread specifications before installation.
• Inspect brake hoses, pads, and rotors during caliper replacement.
• Bleed the brake system after installation to remove air from the hydraulic circuit.
• Use the supplied caliper and pad hardware as required by the application.
• Confirm fitment for the exact vehicle year, make, and model before ordering.

Quality Assurance

Nugeon remanufactures this caliper with a rust preventative finish, included dust boots, slides, and hardware to support a complete brake service on the listed applications. Part number 99P17353B is built for direct replacement use on compatible front right brake systems.