Nugeon 99P17364B Disc Brake Caliper - Rear Right

Rear Right Disc Brake Caliper for GM Minivans

Nugeon TechShield 360 (tm) part number 99P17364B is a remanufactured rear right disc brake caliper with bracket for select Chevrolet, Pontiac, Buick, and Saturn applications. It is built with a cast iron housing, grey rust-preventative finish, and included dust boots, slides, and hardware for the brake hydraulic side of the rear brake system.

Compatible With 2005-2009 Chevrolet Uplander, rear right; 2005-2009 Pontiac Montana, rear right; 2005-2007 Buick Terraza, rear right; and 2005-2007 Saturn Relay, rear right. The TechShield 360 (tm) product line focuses on corrosion resistance and service-ready brake hydraulic components for vehicles that use a rear disc brake caliper with bracket assembly.

Key Features

• Remanufactured disc brake caliper with bracket included
• Rear right position for listed GM minivan applications
• Cast iron housing with grey rust-preventative finish
• Steel piston, 41 mm outside diameter, single-piston design
• Bleeder screw included with M10-1.0 thread
• Banjo bolt inlet fitting with M10-1.5 inlet thread
• Caliper slides, dust boots, and general hardware included
• Bracket and housing cast numbers: 4103

Product Details

Part number 99P17364B is engineered for rear right brake service on select Chevrolet Uplander, Pontiac Montana, Buick Terraza, and Saturn Relay models. This caliper assembly includes the bracket and uses a banjo bolt inlet connection, making it a direct hydraulic replacement for the specified rear disc brake setup. The TechShield 360 (tm) line adds a rust-preventative finish to help protect the cast iron body in demanding brake environments.

This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

What This Part Helps Address

• Rear brake drag caused by a sticking caliper piston or slide
• Uneven rear braking from a worn hydraulic caliper assembly
• Brake fluid seepage at the caliper inlet or bleeder area
• Corrosion on the caliper body or bracket
• Noisy or inconsistent rear brake operation tied to caliper wear

Installation Notes and Tips

Verify the rear right position, bracket style, inlet thread size, and bleeder screw thread before installation. Transfer or replace brake pads separately, since pads are not included. After installation, bleed the brake system thoroughly and inspect all banjo bolt and bleeder connections for leaks.

Quality Assurance

Nugeon remanufactured brake components are processed for brake-system service and finished with corrosion-resistant protection through the TechShield 360 (tm) line. Confirm fitment against the listed vehicle applications and cast numbers 4103 before ordering.