Nugeon 99P17672A Disc Brake Caliper - Rear Left

Rear Left Brake Caliper for Jeep Grand Cherokee

This Nugeon TechShield 360 remanufactured disc brake caliper is built for the rear left position on select 1999-2004 Jeep Grand Cherokee models. Part number 99P17672A includes a mounting bracket and brake pad installation hardware where applicable, making it a direct-fit brake hydraulics replacement for the listed application.

Key Features

• Fits 1999-2004 Jeep Grand Cherokee, rear left
• Remanufactured cast iron disc brake caliper
• Grey finish with rust preventative coating
• Phenolic piston with 48 mm outside diameter
• Bracket included for the listed application
• Bleeder screw, dust boots, caliper slides, and hardware included
• Banjo bolt inlet fitting with 3/8-24 inlet thread
• Supplied with brake pad installation hardware and copper crush washers where applicable

Product Details

Nugeon TechShield 360 is a brake hydraulics product line focused on remanufactured calipers with application-specific hardware and corrosion-resistant finishing. This 99P17672A rear left caliper for Jeep Grand Cherokee models uses a cast iron housing, a phenolic piston, and a rust preventative grey finish to support consistent brake service on the listed vehicles. The assembly is supplied with the bracket, bleeder screw, dust boots, caliper slides, and pad hardware, and it uses a banjo bolt inlet connection with 3/8-24 thread sizing.

Fits 1999-2004 Jeep Grand Cherokee, rear left. Fits 1999-2004 Jeep Grand Cherokee, rear left. This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

Common Brake Issues This Part Addresses

• Rear left caliper sticking or dragging
• Uneven rear brake pad wear
• Brake fluid seepage at the caliper or bleeder screw area
• Corrosion on the caliper body or bracket
• Reduced braking response from a worn hydraulic caliper assembly

Installation Notes

Verify rear left fitment before installation on 1999-2004 Jeep Grand Cherokee models. Confirm the banjo bolt inlet connection, 3/8-24 thread sizing, and bracket configuration match the original brake setup. Inspect brake hoses, pads, and rotor condition during service, and bleed the brake system after installation to remove air from the hydraulic circuit.

Quality Assurance

This Nugeon brake caliper is remanufactured and finished with a rust preventative coating for service use in the listed application. TechShield 360 identifies the product line used for this brake hydraulics replacement.