Nugeon 99P17672B Disc Brake Caliper - Rear Right

Rear Right Brake Caliper for Jeep Grand Cherokee

This remanufactured Nugeon disc brake caliper is built for the rear right position on select Jeep Grand Cherokee models. Part number 99P17672B is a fitment-specific brake hydraulics replacement for 1999-2004 Jeep Grand Cherokee applications with the supplied mounting bracket and TechShield 360 (tm) protection.

Nugeon TechShield 360 (tm) focuses on corrosion resistance and service-ready brake hardware details. For Jeep Grand Cherokee rear brake service, 99P17672B provides a grey cast iron caliper body, rust preventative finish, phenolic piston construction, and included caliper slides, dust boots, bleeder screw, and pad installation hardware where applicable.

Key Features

• Fits 1999-2004 Jeep Grand Cherokee, rear right
• Remanufactured disc brake caliper with bracket included
• Grey cast iron housing with rust preventative finish
• Phenolic piston with 2-inch (48 mm) outside diameter
• Bleeder screw included; banjo bolt inlet fitting
• Caliper slides, dust boots, and brake pad installation hardware included where applicable
• Nugeon TechShield 360 (tm) product line

Detailed Description

Part number 99P17672B is a rear right disc brake caliper for 1999-2004 Jeep Grand Cherokee models. It is remanufactured from cast iron and finished with rust preventative coating to support long-term brake system service. The caliper uses a single phenolic piston and includes the bracket, slides, dust boots, and bleeder screw for a complete hydraulic caliper assembly. The inlet uses a banjo bolt connection with 3/8-24 thread sizing.

Nugeon TechShield 360 (tm) is the brand line associated with added corrosion-focused protection and service-oriented brake component preparation. For Jeep Grand Cherokee rear brake repair, 99P17672B is a direct-fit replacement built around the listed OE-style mounting and hydraulic details.

This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

Common Problems This Part Can Address

• Rear brake drag caused by a sticking caliper piston
• Uneven rear braking on the Jeep Grand Cherokee
• Brake fluid leakage at the caliper or bleeder area
• Corrosion-related caliper seizure or slide binding
• Brake noise or poor pedal response from worn hydraulic components

Installation Notes and Tips

Verify rear right placement before installation and confirm the banjo bolt connection, inlet thread size, and bleeder screw thread match the vehicle’s brake line setup. Inspect the bracket, slides, and dust boots during service, and replace worn brake pads and related hydraulic components as needed for a complete repair. Bleed the brake system after installation to remove air from the circuit.

Quality Assurance

Nugeon remanufactured brake components are prepared for brake system service with attention to fitment, corrosion resistance, and hardware details listed for the application. TechShield 360 (tm) identifies the product line used for this Jeep Grand Cherokee rear right caliper.