Nugeon 99P17694A Disc Brake Caliper - Front Right

Front Right Brake Caliper for Dakota

Nugeon TechShield 360 (tm) 99P17694A is a remanufactured disc brake caliper for the front right position on select 2003-2004 Dodge Dakota models. It is built with a cast iron housing, grey rust-preventative finish, and phenolic pistons for service-ready brake hydraulics performance.

For shoppers searching for a 2003-2004 Dodge Dakota front right brake caliper, this unit includes a mounting bracket, caliper slides, dust boots, hardware, and a bleeder screw. The Bosch design note and TechShield 360 (tm) product line reference help identify the application and corrosion-focused finish.

Key Features

• Fits 2003-2004 Dodge Dakota, front right
• Remanufactured disc brake caliper from Nugeon
• TechShield 360 (tm) rust-preventative finish
• Cast iron housing with grey coating
• Phenolic pistons with 2 in. / 51 mm outside diameter
• Bleeder screw included with M10-1.0 thread
• Bracket included for the listed application
• Caliper slides and dust boots included
• Banjo bolt inlet fitting with M10-1.0 inlet port

Product Details

Part number 99P17694A is a remanufactured front right brake caliper engineered for the 2003-2004 Dodge Dakota. It uses a Bosch design reference and a 2-piston layout with phenolic pistons, which are commonly used in brake hydraulic assemblies for controlled movement and heat resistance. The TechShield 360 (tm) line focuses on a rust-preventative finish to support long-term service in demanding brake environments.

This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

Common Brake Issues It Can Address

• Uneven braking from a sticking front right caliper
• Brake drag caused by worn or seized caliper slides
• Fluid seepage at the bleeder screw or inlet connection
• Corrosion-related caliper movement problems
• Reduced braking response from a worn hydraulic caliper assembly

Installation Notes

Verify the front right position and Bosch design match before installation on your Dodge Dakota. The caliper uses a banjo bolt inlet fitting and M10-1.0 inlet thread, so confirm the brake hose connection and hardware fitment during service. Brake pad installation hardware is listed in the package contents where applicable, but pads are not included.

Bleed the brake system after installation and inspect all connections for leaks before returning the vehicle to service. Confirm rotor condition, pad wear, and slide movement during the repair.

Quality Assurance

Nugeon TechShield 360 (tm) remanufactured brake components are built for brake hydraulic replacement applications with attention to fit, finish, and corrosion resistance. Part number 99P17694A is specified for the listed 2003-2004 Dodge Dakota front right application.