Nugeon 99P17697B Disc Brake Caliper - Rear Left

Rear Left Brake Caliper for Ram and Dodge Applications

Nugeon TechShield 360 (tm) part number 99P17697B is a remanufactured rear left disc brake caliper built for select Ram, Dodge, and Chrysler applications. It includes a mounting bracket and uses a 54 mm phenolic piston for consistent hydraulic response in the rear brake system.

Compatible With 2019-2024 Ram 1500 Classic rear left, 2011-2018 Ram 1500 rear left, 2002-2010 Dodge Ram 1500 rear left, 2007-2009 Chrysler Aspen rear left, and 2004-2009 Dodge Durango rear left. The grey cast iron housing features a rust preventative finish, and the caliper arrives with the bleeder screw, slides, dust boots, and brake pad installation hardware where applicable.

Key Features

• Remanufactured disc brake caliper with bracket included
• TechShield 360 (tm) finish with rust preventative coating
• Grey cast iron housing for rear brake service
• 54 mm phenolic piston with single-piston design
• Bleeder screw included with M10-1.0 thread
• Banjo bolt inlet fitting with M10-1.0 inlet thread
• Caliper slides, dust boots, and hardware included
• Fits rear left brake positions on select Ram, Dodge, and Chrysler vehicles

Product Details

This Nugeon brake caliper is built for rear left applications on Ram 1500 Classic, Ram 1500, Dodge Ram 1500, Chrysler Aspen, and Dodge Durango models listed in the fitment data. Part number 99P17697B uses a phenolic piston and a bracketed design to match the original rear brake layout on these vehicles. The TechShield 360 (tm) line focuses on corrosion resistance and service-ready components for brake hydraulic replacement work.

This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

Common Problems This Part Addresses

• Rear brake drag caused by a sticking caliper piston
• Uneven braking from worn or corroded caliper hardware
• Brake fluid seepage at the bleeder or inlet connection
• Noise or vibration related to caliper wear and slide issues
• Reduced rear brake performance on Ram, Dodge, or Chrysler rear left applications

Installation Notes and Tips

Verify rear left fitment by year, make, and model before installation. Confirm the banjo bolt connection, M10-1.0 thread sizes, and bracketed caliper layout match the original part on the vehicle. Transfer or replace brake fluid as needed during service, and bleed the hydraulic system after installation to remove air from the line.

Because this caliper is supplied with a bracket, make sure the mounting points and rotor clearance are correct before final assembly. Inspect pads, hoses, and related brake hardware for wear while servicing the rear brake system on Ram 1500, Dodge Ram 1500, or Chrysler Aspen applications.

Quality Assurance

Nugeon TechShield 360 (tm) remanufactured brake components are built for brake hydraulic replacement work with corrosion-resistant finishing and application-specific hardware details. Part number 99P17697B is specified for the listed rear left vehicle applications and is prepared for direct-fit brake service where the original configuration matches the fitment data.