Nugeon 99P17716A Disc Brake Caliper - Front Left or Front Right

Front Brake Caliper for Chrysler and Dodge

This Nugeon TechShield 360 disc brake caliper is a remanufactured front brake hydraulic replacement built for select Chrysler and Dodge applications. Part number 99P17716A is configured with a mounting bracket, bleeder screw, slides, dust boots, and brake pad installation hardware where applicable.

It is a direct-fit front caliper solution for vehicles such as the Chrysler 300, Dodge Charger, Dodge Challenger, and Dodge Magnum in the listed positions. The grey aluminum housing uses a rust preventative finish and a phenolic piston for consistent brake operation.

Key Features

• Brand: Nugeon TechShield 360
• Part number: 99P17716A
• Remanufactured disc brake caliper
• Front left and front right applications, depending on vehicle listing
• Aluminum caliper housing with rust preventative finish
• Phenolic piston with 60 mm outside diameter
• Bracket included for listed applications
• Bleeder screw, caliper slides, dust boots, and hardware included
• Banjo bolt inlet fitting with M10-1.5 inlet thread

Product Details

The TechShield 360 line focuses on brake hydraulic components prepared for direct replacement use. This caliper is built with a single phenolic piston, integrated bleeder screw, and a banjo bolt inlet connection to match the listed OE-style brake system layouts. The housing cast number is K246-059C, and the unit is finished in grey with rust preventative protection.

Fits 2005-2011 Chrysler 300, front right and front left; 2006-2011 Dodge Charger, front right and front left; 2009-2011 Dodge Challenger, front right; and 2005-2008 Dodge Magnum, front right. Part number 99P17716A is also a useful reference when searching for a front brake caliper for Chrysler 300 or Dodge Charger brake repair.

This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

What This Caliper Helps Address

• Brake fluid leakage at the caliper body or bleeder area
• Uneven pad contact caused by sticking or worn caliper components
• Brake pull related to a seized front caliper
• Corrosion on the original caliper housing or hardware
• Noisy or inconsistent braking from worn hydraulic caliper parts

Installation Notes and Tips

Verify the vehicle position, bracket style, inlet fitting, and bleeder thread before installation. Transfer or replace brake pads as needed, and bleed the brake system after installation to remove air from the hydraulic circuit. Confirm rotor condition and inspect hoses, banjo bolt sealing surfaces, and mounting points before returning the vehicle to service.

Quality Assurance

Nugeon TechShield 360 brake components are remanufactured for direct replacement use and built to match the listed fitment and hardware configuration. Confirm the part number 99P17716A against the vehicle application before ordering.