Nugeon 99P17758A Disc Brake Caliper - Rear Left

Rear Left Disc Brake Caliper for Durango and Grand Cherokee

This Nugeon TechShield 360 disc brake caliper is a remanufactured rear left replacement for select 2011-2020 Dodge Durango and Jeep Grand Cherokee models with a solid disc brake setup. Part number 99P17758A is built with a cast iron housing, phenolic piston, and rust preventative finish for direct brake hydraulic service.

Key Features

• Fits 2011-2020 Dodge Durango, rear left, supplied with mounting bracket; w/ solid disc; TechShield 360 (tm)
• Fits 2011-2020 Jeep Grand Cherokee, rear left, supplied with mounting bracket; w/ solid disc; TechShield 360 (tm)
• Remanufactured disc brake caliper with bracket included
• Grey caliper with rust preventative finish
• Cast iron housing with 48 mm phenolic piston
• Bleeder screw included; dust boots included; caliper slides included
• Banjo bolt inlet fitting with M10-1.0 inlet thread
• Brake pad installation hardware included where applicable

Product Details

Nugeon TechShield 360 is a brake hydraulics product line focused on replacement calipers prepared for demanding daily driving conditions. This 99P17758A rear left disc brake caliper includes the bracket and slide components needed for the specified applications, along with a bleeder screw and dust boots to support serviceable brake system maintenance. The phenolic piston helps reduce heat transfer through the caliper assembly, while the rust preventative finish supports long-term corrosion resistance on the rear axle.

Use this caliper when servicing a 2011-2020 Dodge Durango or 2011-2020 Jeep Grand Cherokee with the matching rear left, solid disc configuration. Part number 99P17758A is a direct-fit brake hydraulic replacement for the listed applications and is built around the TechShield 360 (tm) product line.

This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

Common Problems This Part Can Address

• Rear brake drag caused by a sticking caliper piston or slide assembly
• Uneven rear braking from worn hydraulic components
• Brake fluid seepage at the caliper or bleeder area
• Corrosion-related caliper seizure on the rear left side
• Noisy or inconsistent rear brake operation after caliper wear

Installation Notes and Tips

Verify rear left position, solid disc brake configuration, and banjo bolt inlet style before installation. Confirm the M10-1.0 inlet and bleeder thread sizes match the vehicle brake line and service fittings. Bleed the brake system after installation and inspect all connections for leaks before returning the vehicle to service.

Quality Assurance

This Nugeon caliper is remanufactured and finished with rust preventative coating for brake system replacement service. TechShield 360 (tm) identifies the product line used for these rear brake hydraulic applications.