Nugeon 99P17758B Disc Brake Caliper - Rear Right

Rear Right Disc Brake Caliper for Durango and Grand Cherokee

This Nugeon TechShield 360 disc brake caliper is a remanufactured rear right replacement for select 2011-2020 Dodge Durango and Jeep Grand Cherokee models with a solid disc setup. Part number 99P17758B is built with a cast iron housing, phenolic piston, and rust preventative finish for a direct-fit brake hydraulics repair.

Key Features

• Fits 2011-2020 Dodge Durango, rear right, supplied with mounting bracket and solid disc application notes
• Fits 2011-2020 Jeep Grand Cherokee, rear right, supplied with mounting bracket and solid disc application notes
• Remanufactured caliper with grey rust preventative finish
• Cast iron housing with one 48 mm phenolic piston
• Includes bleeder screw, dust boots, caliper slides, bracket, and hardware
• Banjo bolt inlet fitting with M10-1.0 inlet thread size
• Bleeder screw thread: M10-1.0 x 28

Product Details

Nugeon TechShield 360 99P17758B is a rear right disc brake caliper engineered for the Dodge Durango and Jeep Grand Cherokee applications listed above. The TechShield 360 product line focuses on brake hydraulics components with corrosion-resistant finishing and application-specific remanufacturing details, making this caliper a practical OE-style replacement when the original rear caliper is worn, sticking, or leaking. The unit includes a bracket, slides, bleeder screw, dust boots, and brake pad installation hardware with banjo bolt and copper crush washers where applicable. This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

Common Problems This Part Can Address

• Rear brake drag caused by a sticking caliper piston or slide
• Brake fluid leakage at the caliper or bleeder screw area
• Uneven rear braking on Dodge Durango or Jeep Grand Cherokee models
• Corrosion-related caliper seizure on the rear right corner
• Reduced braking response from a worn remanufactured caliper assembly

Installation Notes and Tips

Verify rear right fitment before installation and confirm the vehicle uses a solid disc rear brake setup. Inspect the banjo bolt connection, inlet thread size, and bleeder screw thread during installation, and bleed the brake system thoroughly after replacement. Check pad condition, rotor surface, and slide movement so the new caliper can operate correctly.

Quality Assurance

Part number 99P17758B is remanufactured to restore brake function with the specified hardware and component details listed above. The TechShield 360 line adds a rust preventative finish and application-specific brake hydraulics construction for the listed Dodge Durango and Jeep Grand Cherokee rear right applications.