Nugeon 99P17888A Disc Brake Caliper - Front Right

Front Right Disc Brake Caliper for Ranger and Explorer

Nugeon TechShield 360 (tm) part number 99P17888A is a remanufactured front right disc brake caliper built for specific Ford, Mazda, and Mercury applications. It includes the mounting bracket and brake pad installation hardware where applicable, making it a direct-fit brake hydraulics replacement for vehicles such as the Ford Ranger, Mazda B3000, and Ford Explorer.

Key Features

• Remanufactured disc brake caliper for the front right position
• TechShield 360 (tm) product line with rust preventative finish
• Cast iron housing with grey caliper color
• Phenolic pistons with 46 mm outside diameter
• Bracket included for the specified applications
• Bleeder screw included with 3/8-24 thread
• Caliper slides, dust boots, and hardware included
• Banjo bolt inlet fitting with copper crush washers where applicable
• Brake pad installation hardware included where applicable
• Part number 99P17888A for catalog and fitment verification

Product Details

Nugeon TechShield 360 (tm) focuses on corrosion resistance and service-ready brake hydraulics components. This 99P17888A front right caliper uses a cast iron body, phenolic pistons, and a rust preventative finish to support consistent brake operation in the listed applications. It is a remanufactured unit supplied with the bracket, slides, dust boots, bleeder screw, and related hardware noted for the application, helping simplify replacement on vehicles that use this caliper style. This part number 99P17888A is listed for the front right side on Ford Ranger, Mazda B2300, Mazda B4000, Mazda B3000, Ford Explorer, Mercury Mountaineer, Ford Explorer Sport, and Ford Explorer Sport Trac applications.

Common Problems This Part Addresses

• Sticking or seized front right brake caliper
• Uneven braking caused by worn piston seals or slides
• Brake fluid leakage at the caliper body or bleeder area
• Corrosion on the caliper housing or bracket
• Poor pad movement from worn hardware or dust boots

Installation Notes

Verify the vehicle’s front right brake configuration before installation. Confirm the inlet thread size, bleeder screw thread, and bracket style match the original setup on the Ford Ranger, Mazda B3000, or Ford Explorer application. Transfer or replace brake pads as needed, bleed the hydraulic system after installation, and inspect the banjo bolt sealing surfaces and copper crush washers where applicable. Part number 99P17888A should be matched to the vehicle’s year, make, model, and position before service.

Quality Assurance

TechShield 360 (tm) identifies Nugeon’s brake component line focused on corrosion-resistant remanufactured hydraulics. This caliper is built with the listed materials and service components to support OE-style replacement requirements for the specified front right applications.