Nugeon 99P17892A Disc Brake Caliper - Front Right

Front Right Disc Brake Caliper for Ford F-150

This Nugeon TechShield 360 disc brake caliper is a remanufactured front right replacement for select Ford F-150, Ford F-150 Heritage, and Lincoln Blackwood applications. Part number 99P17892A is built with a cast iron housing, phenolic pistons, and a rust preventative finish for service-ready brake hydraulics replacement.

Key Features

• Fits 1997-1998 Ford F-150, front right, with rear disc brakes and mounting bracket
• Fits 1999-2003 Ford F-150, front right, with 5-lug wheel, rear disc brakes, and mounting bracket
• Fits 2004 Ford F-150 Heritage, front right, with rear disc brakes and mounting bracket
• Fits 2002 Lincoln Blackwood, front right, with mounting bracket
• Remanufactured caliper with cast iron housing and grey rust preventative finish
• Phenolic piston design with 2-inch piston diameter and bleeder screw included
• Bracket, caliper slides, dust boots, and caliper/pad hardware included
• Banjo bolt inlet fitting with 3/8-24 thread size

Product Details

Nugeon TechShield 360 99P17892A is a front right disc brake caliper engineered for direct replacement on the listed Ford and Lincoln truck applications. The caliper uses a cast iron body, phenolic pistons, and a rust preventative coating to support dependable brake hydraulic service. It includes the bracket, slides, dust boots, bleeder screw, and brake pad installation hardware with banjo bolt and copper crush washers where applicable. This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

Common Brake Issues This Part Can Address

• Uneven braking from a sticking or seized front right caliper
• Brake fluid leakage at the caliper or bleeder screw area
• Poor pad movement caused by worn slides or damaged hardware
• Corrosion-related caliper binding on older Ford F-150 brake systems
• Reduced braking response from a worn hydraulic caliper assembly

Installation Notes and Tips

Verify front right position, inlet thread size, and vehicle brake configuration before installation. Confirm the caliper bracket and banjo bolt connection match the original setup, and bleed the brake system after installation to remove air from the hydraulic circuit. Inspect pads, rotors, and brake hoses for wear or damage before returning the vehicle to service. Part number 99P17892A is listed for 1997-2004 Ford F-150 and 2002 Lincoln Blackwood front right applications only.

Quality Assurance

Nugeon TechShield 360 remanufactured brake components are rebuilt for direct-fit hydraulic replacement and application-specific compatibility on the listed vehicles. Part number 99P17892A is intended for the confirmed Ford F-150, Ford F-150 Heritage, and Lincoln Blackwood fitments shown above.