Nugeon 99P17892B Disc Brake Caliper - Front Left

Front Left Disc Brake Caliper for Ford F-150 Heritage

This Nugeon TechShield 360 disc brake caliper is a remanufactured front left brake hydraulic component built for select Ford F-150, Ford F-150 Heritage, and Lincoln Blackwood applications. Part number 99P17892B includes a mounting bracket and is finished with a rust preventative coating for service in demanding brake environments.

Key Features

• Remanufactured cast iron disc brake caliper with grey finish
• TechShield 360 product line for brake hydraulic replacement applications
• Front left position with supplied mounting bracket
• Phenolic pistons with 2-inch outside diameter
• Bleeder screw included with 3/8-24 thread
• Caliper slides, dust boots, and brake pad installation hardware included
• Banjo bolt inlet fitting with copper crush washers where applicable
• Housing cast number 6182

Detailed Description

Nugeon 99P17892B is a remanufactured disc brake caliper for the front left side of select Ford and Lincoln trucks. It uses a cast iron housing, phenolic pistons, and a rust preventative finish to support brake system service where corrosion resistance and consistent hydraulic operation matter. The TechShield 360 line identifies this brake hydraulic replacement as part of Nugeon’s application-specific product offering.

Fits 1997-1998 Ford F-150, front left; fits 1999-2003 Ford F-150, front left; fits 2004 Ford F-150 Heritage, front left; fits 2002 Lincoln Blackwood, front left. This part number, 99P17892B, is a direct fitment reference for these front left brake applications.

What It Helps Address

• Sticking or seized front left caliper operation
• Uneven brake pad wear caused by caliper drag
• Brake fluid leakage at the caliper body or bleeder area
• Corrosion on the caliper housing or hardware surfaces
• Reduced braking response from worn hydraulic components

Installation Notes and Tips

Verify the vehicle uses the listed front left configuration before installation. This caliper is supplied with a bracket, bleeder screw, caliper slides, dust boots, and brake pad installation hardware; pads are not included. The inlet uses a banjo bolt connection, and the bleeder screw thread is 3/8-24. Inspect brake hoses, pads, and rotor condition during service, and confirm proper bleeding after installation.

Quality Assurance

This remanufactured Nugeon caliper is built as a brake hydraulic replacement for the listed Ford F-150, Ford F-150 Heritage, and Lincoln Blackwood applications. TechShield 360 identifies the product line used for this application-specific caliper, and the rust preventative finish supports long-term serviceability.