Nugeon 99P17927A Disc Brake Caliper - Front Left

Nugeon TechShield 360 Disc Brake Caliper

Nugeon 99P17927A is a remanufactured front left disc brake caliper for the 2004-2007 Ford Focus. It includes the bracket, caliper slides, dust boots, bleeder screw, and brake pad installation hardware with banjo bolt and copper crush washers where applicable.

Built in the TechShield 360 line, this caliper uses a rust-preventative grey finish and cast iron housing for service-ready brake hydraulics on the Ford Focus front left position.

Key Features

• Fits 2004-2007 Ford Focus, front left
• Remanufactured disc brake caliper with bracket included
• Cast iron housing with rust preventative grey finish
• 57 mm steel piston for hydraulic braking force
• Bleeder screw included with M8-1.25 thread
• Caliper slides, dust boots, and brake pad hardware included
• Inlet port thread size: M10-1.0
• Housing cast numbers: 789, LH

Detailed Description

Nugeon 99P17927A is a front left disc brake caliper for the 2004-2007 Ford Focus, engineered as a remanufactured replacement for the original brake hydraulic assembly. The TechShield 360 line adds a rust-preventative finish to help protect the cast iron caliper body, while the included bracket, slides, dust boots, and bleeder screw support a complete service replacement on the Ford Focus front brake corner. The 57 mm steel piston and M10-1.0 inlet port match the listed application requirements for this part number.

This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

What This Caliper Helps Address

• Uneven front brake pad wear on the left side
• Brake fluid leakage at the caliper body or bleeder area
• Sticking or seized caliper piston movement
• Corrosion on the caliper housing or slides
• Reduced braking response from a worn hydraulic caliper

Installation Notes and Tips

Fits 2004-2007 Ford Focus, front left. Verify the inlet thread size, bleeder thread size, and bracket style before installation. Transfer or replace brake pads as needed, and bleed the brake system after installation to remove air from the hydraulic circuit. Confirm the banjo bolt and copper crush washer application where applicable during assembly.

Quality Assurance

Nugeon TechShield 360 calipers are remanufactured brake components built for direct replacement use in the listed Ford Focus application. The part is supplied with the listed hardware and protective finish details shown above.