Nugeon 99P17927B Disc Brake Caliper - Front Right

Front Right Disc Brake Caliper for Ford Focus

Nugeon TechShield 360 (tm) 99P17927B is a remanufactured front right disc brake caliper for 2004-2007 Ford Focus models. It is built with a cast iron housing, a 57 mm steel piston, and a rust preventative finish for service replacement on the front brake system.

Key Features

• Fits 2004-2007 Ford Focus, front right
• Remanufactured disc brake caliper with TechShield 360 (tm) protection
• Cast iron housing with grey rust preventative finish
• Includes bracket, caliper slides, dust boots, bleeder screw, and brake pad installation hardware
• Single 57 mm steel piston for front disc brake operation
• Inlet port thread size: M10-1.0
• Bleeder screw thread size: M8-1.25 x 30.2
• Housing cast number: 790, RH

Detailed Description

This Nugeon disc brake caliper, part number 99P17927B, is specified for the front right position on 2004-2007 Ford Focus vehicles. The TechShield 360 (tm) product line focuses on corrosion resistance and service-ready replacement construction, making this caliper a practical choice when restoring front brake function on a Ford Focus. The unit includes the bracket and related caliper service components listed in the product data, along with a bleeder screw and pad installation hardware where applicable.

As a remanufactured brake hydraulics component, 99P17927B is built around a cast iron body and a steel piston to support consistent hydraulic actuation. The grey finish and dust boots help protect the assembly during everyday road use. This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

What This Caliper Helps Address

• Uneven or reduced front brake clamping on the right side
• Brake drag caused by a sticking piston or worn slide components
• Fluid seepage at the caliper body or bleeder area
• Corrosion-related caliper wear on a Ford Focus front brake assembly
• Brake noise or poor pad movement related to caliper hardware wear

Installation Notes and Tips

Verify the front right position, inlet thread size, and bleeder screw thread before installation. Inspect brake hoses, pads, and rotor condition during caliper replacement, and bleed the hydraulic system after installation to remove air from the circuit. Confirm the bracket and slide movement are clean and properly lubricated before returning the vehicle to service. Fits 2004-2007 Ford Focus, front right.

Quality Assurance

Nugeon TechShield 360 (tm) calipers are remanufactured brake components built for direct-fit service replacement in the listed application. Part number 99P17927B is matched to the specified Ford Focus front right fitment and component dimensions shown in the product data.