Nugeon 99P17955A Disc Brake Caliper - Front Right

Front Right Disc Brake Caliper for Ford E-Series

Nugeon TechShield 360 (tm) disc brake caliper Part Number 99P17955A is a remanufactured front right brake hydraulic component for select Ford E-Series vans. It is built with a cast iron housing, phenolic pistons, and a rust preventative finish to support consistent braking performance in demanding daily-use applications.

Key Features

• Remanufactured front right disc brake caliper
• Cast iron housing with grey rust preventative finish
• Phenolic piston design with 2-inch (60 mm) piston diameter
• Bleeder screw included with 3/8-24 thread
• Bracket included for the specified front right application
• Caliper slides and dust boots included
• Banjo bolt inlet fitting type
• Brake pad installation hardware included where applicable

TechShield 360 (tm) Product Line

Nugeon TechShield 360 (tm) focuses on brake hydraulics with corrosion-resistant finishing and application-specific remanufacturing. For this Ford E-350 Super Duty, Ford E-150, and Ford E-250 front right caliper application, the line emphasizes fitment accuracy, serviceable hardware, and a ready-to-install hydraulic assembly for the listed vehicles.

Detailed Description

Part Number 99P17955A is a front right disc brake caliper for 2008-2025 Ford E-350 Super Duty, 2008-2014 Ford E-150, and 2008-2014 Ford E-250 applications listed in the fitment data. It uses a dual phenolic piston setup, includes the mounting bracket, and comes with the bleeder screw, slides, dust boots, and hardware noted in the product attributes. The banjo bolt inlet and 3/8-24 thread specification support direct hydraulic connection for the confirmed applications.

This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

Common Brake Issues This Caliper Can Address

• Uneven front brake pad wear on the right side
• Brake fluid seepage at the caliper body or bleeder area
• Sticking or restricted caliper piston movement
• Corrosion-related caliper performance loss
• Poor brake pedal response caused by a worn hydraulic caliper

Installation Notes and Tips

• Verify front right position and confirm the vehicle is listed in the fitment data before installation.
• Inspect the banjo bolt connection, copper crush washers, and brake hose sealing surfaces during service.
• Bleed the brake system after installation to remove air from the hydraulic circuit.
• Check pad condition, rotor wear, and slide movement before returning the vehicle to service.
• Confirm bracket and inlet thread specifications match the original caliper setup.

Quality Assurance

Nugeon remanufactures this caliper for the specified Ford E-Series applications using a rust preventative finish, phenolic pistons, and application-matched hardware details to support reliable brake service. Part Number 99P17955A is built for the confirmed front right fitment listed above.