Nugeon 99R06308A Disc Brake Caliper - Rear Right

Rear Right Brake Caliper for Fiat 500

Nugeon 99R06308A is a remanufactured rear right disc brake caliper for 2012-2019 Fiat 500 models. It includes the mounting bracket and installation hardware details listed for the application, along with a red powder-coated finish for a clean, corrosion-resistant appearance.

This Nugeon reman caliper w/ installation hardware is built around a single 34 mm steel piston, aluminum housing, and included dust boots, slides, bleeder screw, and caliper/pad hardware. The part number 99R06308A is a direct fit for the rear right position on the Fiat 500, making it a practical replacement for worn or sticking brake hardware.

Key Features

• Fits 2012-2019 Fiat 500, rear right
• Remanufactured disc brake caliper with bracket included
• Red powder-coated finish
• Aluminum caliper housing with steel piston
• Bleeder screw included with M10-1.0 thread
• Caliper slides, dust boots, and caliper/pad hardware included
• Inlet port thread size: M10-1.0
• Bracket cast numbers: 179269, 6976
• Housing cast number: 17926601

Product Details

Nugeon’s Reman Caliper w/ Installation Hardware line focuses on replacement brake hydraulics that match the original application requirements while restoring proper caliper function. Part number 99R06308A is specified for the rear right side of the Fiat 500 and uses a line-style inlet fitting, a 34 mm piston, and a bracketed design for the listed fitment. If you are searching for a rear right brake caliper for Fiat 500 2012-2019 models, this unit provides the core hardware needed for a complete caliper replacement.

This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

Common Problems This Part Can Address

• Brake drag caused by a sticking rear caliper
• Uneven rear brake wear on the Fiat 500
• Leaking or corroded caliper housing
• Reduced braking response from worn piston or seals
• Noise or vibration related to worn caliper hardware

Installation Notes

Verify rear right placement, inlet thread size, and bracket cast numbers before installation. Bleeder screw, slides, dust boots, and caliper/pad hardware are listed for this application; pads are not included. Always inspect brake hoses, pads, and rotors during caliper replacement, and bleed the hydraulic system after installation.

Quality Assurance

This Nugeon remanufactured caliper is built as a brake hydraulic replacement for the specified Fiat 500 applications and finished with powder coating for added surface protection.