Nugeon 99R18050A Disc Brake Caliper - Rear Right

Remanufactured brake caliper for Fiesta

This Nugeon remanufactured disc brake caliper is built for direct replacement service on the rear right side of compatible applications. It is identified by part number 99R18050A and is listed for Ford Fiesta models with rear disc brakes and a red caliper finish.

Key features

• Remanufactured disc brake caliper with a cast iron housing
• Includes caliper slides, bleeder screw, bracket, and caliper-and-pad hardware
• Powder-coated red finish for a clean, corrosion-resistant appearance
• Single-piston design with a 34 mm piston diameter
• Lucas-style caliper configuration with M10-1.0 inlet thread and M7-1.0 bleeder thread

Detailed description

Part number 99R18050A is a remanufactured rear right disc brake caliper engineered around the listed Lucas caliper design. The cast iron body, steel piston, dust boots, and included slides support a complete hydraulic replacement for the brake corner, while the red powder-coated finish matches the application listing. This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

Compatible With Ford Fiesta rear brake service, this caliper is listed for 2014-2019 Ford Fiesta models with rear disc brakes. Use 99R18050A when replacing a worn or sticking rear right caliper on a Ford Fiesta, and verify the brake hose connection and bracket style against the existing unit before installation.

What it is used for

• Restoring rear brake clamping force when the caliper is seized or sticking
• Replacing a leaking hydraulic caliper body or damaged bleeder screw
• Addressing uneven rear brake wear caused by piston or slide wear
• Correcting brake drag, pull, or inconsistent pedal response at the rear wheel

Installation notes and tips

Confirm rear right fitment, rear disc brake configuration, and the existing caliper casting and bracket style before ordering. The package contents note brake pad installation hardware with banjo bolt and copper crush washers where applicable, but pad fitment should still be matched to the vehicle’s brake setup. Bleeder screw size is M7-1.0 and inlet thread size is M10-1.0.

Quality assurance

Nugeon remanufactured calipers are built as service replacements for brake hydraulic repair. Part number 99R18050A is supplied with a remanufactured housing, hardware-related components listed above, and a powder-coated finish for the specified application.