One Stop Solutions 3290 A/C Condenser

OE-Style A/C Condenser for Honda and Acura

One Stop Solutions Part Number 3290 is a premium new A/C condenser built to match original equipment form and function. It is engineered for direct replacement use on 2003-2008 Honda Pilot and 2001-2006 Acura MDX applications, with aluminum construction for efficient heat transfer and a fit that follows OE-style mounting and connection points.

• Aluminum construction for efficient heat dissipation
• Extruded condenser tubes for structural integrity
• Louvered aluminum fins bonded with furnace-brazing for thermal performance
• Individually pressure tested before release
• Block fitting inlet and outlet connections
• Drier included
• Engineered for multi-fit without changing the look or fit

Detailed Product Overview

This One Stop Solutions condenser, Part Number 3290, uses a parallel flow core design with an 11/16-inch core thickness, 27 3/16-inch core width, and 20 3/16-inch core length. The aluminum core and brazed fin-and-tube construction are selected to support heat exchange efficiency in the vehicle’s air conditioning system. For shoppers searching for a Honda Pilot A/C condenser replacement or an Acura MDX condenser replacement, this unit is built around the OE-style dimensions and block fitting layout needed for a clean installation.

This part cross-references Spectra Premium 7-3290 for the same application.

Common Problems This Part Can Address

• Loss of A/C cooling performance from a leaking or damaged condenser
• Restricted refrigerant flow caused by internal condenser damage
• Corrosion or physical damage to the original condenser core
• Fitment issues when replacing a worn condenser on Honda Pilot or Acura MDX models
• Reduced heat rejection in the air conditioning system

Installation Notes and Tips

Verify the vehicle’s condenser connection style before installation; this unit uses block fittings at both the inlet and outlet. Inspect adjacent A/C components, lines, and seals for wear before reassembly, and evacuate and recharge the system according to factory service procedures after installation. Confirm fitment for 2003-2008 Honda Pilot and 2001-2006 Acura MDX applications before ordering.

Quality Assurance

Each condenser is individually pressure tested to help confirm integrity before it leaves the factory. The furnace-brazed aluminum construction and OE-style engineering are intended to support dependable service and consistent fit on the listed Honda Pilot and Acura MDX applications. Part Number 3290 is built as a new replacement condenser for direct-service use.