One Stop Solutions 4811 A/C Condenser

OE-Style A/C Condenser for Lexus and Toyota

One Stop Solutions Part Number 4811 is a premium new A/C condenser built to match original equipment form and function. It is engineered for direct replacement use on select Lexus ES300 and Toyota Camry applications, with aluminum construction for efficient heat transfer and a fit focused on OE-style appearance.

• Designed to Original Equipment form and function
• Aluminum construction for heat transfer efficiency
• Extruded condenser tubes for structural integrity
• Louvered aluminum fins bonded with a furnace-brazing process
• Individually pressure tested for quality control
• Engineered for multi-fit without compromising performance or appearance
• O-ring inlet and outlet fittings

Detailed Product Overview

This One Stop Solutions condenser uses a serpentine core design with a 22 mm (7/8 in.) core thickness, 30 1/2 in. core width, and 16 1/8 in. core length. The aluminum tube-and-fin construction is built to support efficient refrigerant heat exchange, while the brazed fin and tube assembly helps promote consistent dissipation. Part number 4811 is a practical replacement choice when restoring A/C performance on 1997-2001 Lexus ES300 and 1997-1998 Toyota Camry models with two threaded fittings.

This part cross-references APDI 7014811 for the same application.

Common Problems This Part Addresses

• Reduced A/C cooling from a leaking or restricted condenser
• Visible damage to condenser fins or tubes from road debris
• Refrigerant loss caused by corrosion or cracked fittings
• Weak heat rejection that affects cabin air temperature
• Fitment issues when replacing an OE-style condenser on Lexus ES300 or Toyota Camry

Installation Notes and Tips

Verify the vehicle uses two threaded fittings before ordering. Confirm inlet and outlet connection style, mounting points, and core dimensions against the original unit. Replace any worn seals or O-rings during installation, and evacuate and recharge the system according to factory service procedures after the condenser is installed.

Quality Assurance

Each condenser is individually pressure tested before release. The design uses aluminum construction, furnace-brazed fin and tube bonding, and OE-style engineering to support dependable fitment and consistent cooling performance.