Pagid 355250591 Disc Brake Pad Wear Sensor - Rear

Pagid Rear Brake Pad Wear Sensor for BMW Z4

Monitor brake pad condition with this Pagid disc brake pad wear sensor for the rear axle. Built with a 1150 mm wiring harness and a male connector, it matches the needs of the 2003-2008 BMW Z4 rear brake setup and supports accurate wear indication when the pad reaches its service limit.

Pagid’s Made in Europe Wear Sensor line focuses on direct-fit brake wear monitoring components for disc brake systems. Part number 355250591 is a practical replacement choice for BMW Z4 rear brake service, and 355250591 is also referenced by several cross-number listings used for the same application.

Key Features

• Disc brake pad wear sensor for rear brake applications
• 1150 mm wiring harness length for proper routing
• Male connector for vehicle-side connection
• Wiring harness included
• Made in Europe Wear Sensor product line
• Technical Information Number: P8057
• Fits 2003-2008 BMW Z4, rear

Product Details

This Pagid brake wear sensor is built for disc brake systems and is specified for the rear position on the 2003-2008 BMW Z4. It provides the electrical signal used by the vehicle’s brake warning system to indicate pad wear, helping maintain proper service intervals and dashboard warning accuracy. The 1150 mm harness length supports the factory routing path, while the male connector matches the intended connection style for this application. Part number 355250591 is the identifying reference for ordering and service lookup.

This part cross-references Dynamic Friction Company 341-31025 and Four Seasons 24013 for the same application.

What It Helps Address

• Brake wear warning light staying on after pad service
• Damaged or broken rear pad wear sensor wiring
• Incorrect wear signal from an aged sensor
• Service replacement for a worn brake pad monitoring circuit
• Loss of brake pad wear indication on a BMW Z4 rear brake system

Installation Notes

Installation requires qualified personnel. Route the harness carefully to avoid contact with moving suspension parts, hot brake components, or sharp edges. Confirm connector fitment and sensor placement before final assembly, and verify the brake warning system operation after installation. For fitment reference, this sensor is listed for 2003-2008 BMW Z4 rear brake applications.

Quality Assurance

Pagid supplies this wear sensor as part of its Made in Europe Wear Sensor line, with application-specific fitment and technical reference P8057 for service identification.