Pagid 355250651 Disc Brake Pad Wear Sensor - Rear

Rear Brake Pad Wear Sensor for BMW

This Pagid disc brake pad wear sensor monitors rear pad wear and helps trigger the warning system before brake material is fully depleted. It is a Made in Europe Wear Sensor application with a 685 mm wiring harness and male connector for the listed BMW rear brake setups.

Key Features

• Brand: Pagid
• Part number: 355250651
• Disc brake pad wear sensor for rear disc brake applications
• Wiring harness length: 685 mm / 26.97 in
• Male connector with wiring harness included
• Technical Information Number: P8063
• Made in Europe Wear Sensor product line

Fitment and Application

• Fits 2008-2010 BMW 528i, rear
• Fits 2009-2010 BMW 528i xDrive, rear
• Fits 2008-2010 BMW 535i, rear
• Fits 2009-2010 BMW 535i xDrive, rear
• Fits 2006-2010 BMW 550i, rear
• Fits 2006-2010 BMW 650i, rear
• Fits 2006-2010 BMW M5, rear
• Fits 2006-2010 BMW M6, rear
• Fits 2008 BMW 528xi, rear
• Fits 2008 BMW 535xi, rear
• Fits 2004-2007 BMW 525i, rear
• Fits 2006-2007 BMW 525xi, rear
• Fits 2004-2007 BMW 530i, rear
• Fits 2006-2007 BMW 530xi, rear
• Fits 2004-2005 BMW 545i, rear
• Fits 2004-2005 BMW 645Ci, rear

Detailed Description

Pagid 355250651 is a rear disc brake pad wear sensor built for BMW vehicles that use an electronic pad wear warning system. The sensor routes through a 685 mm harness and uses a male connector, making it a direct-match service part for the listed rear brake applications. This part cross-references Febi-Bilstein 23025 and VEMO V20-72-5126 for the same application.

Compatible BMW models include the 528i, 535i, 550i, 650i, M5, M6, 525i, 530i, 545i, and 645Ci in the rear position. If you are replacing a worn brake pad sensor on a BMW 528i rear brake service or a BMW M5 rear brake repair, this Pagid wear sensor matches the specified fitment and connector style.

Common Reasons to Replace

• Brake pad wear warning light stays on after pad service
• Sensor wire is damaged during brake pad replacement
• Brake warning system no longer reports pad wear correctly
• Rear brake service requires a new wear sensor
• Connector or harness damage at the rear axle

Installation Notes

Assy/disassy by qualified personnel required. Inspect the sensor routing, connector condition, and brake pad contact point before installation. Replace the sensor if the harness is cut, melted, or stretched, and verify the rear brake pad wear indicator resets properly after service. Confirm the vehicle’s rear brake configuration against the listed BMW fitment before ordering.

Quality Assurance

Pagid’s Made in Europe Wear Sensor line supports consistent fitment for European brake applications. The part is identified by Technical Information Number P8063 and is cataloged for the BMW rear disc brake applications listed above.