Pagid 355251651 Disc Brake Pad Wear Sensor - Front

Pagid Disc Brake Pad Wear Sensor for BMW Z4

This Pagid disc brake pad wear sensor is built for front brake applications on select 2009-2010 BMW Z4 models, including 2010 BMW Z4 vehicles built to 03/2010. It uses a male connector and includes the wiring harness for a direct replacement on the specified front disc brake setup.

Key Features

• Pagid brake wear sensor for disc brake systems
• Front position application for select BMW Z4 models
• Wiring harness length: 980 mm (38.58 in.)
• Male connector for the listed fitment
• Made in Europe Wear Sensor product line
• Technical Information Number: P8576

Product Details

Pagid 355251651 is a disc brake pad wear sensor engineered for vehicles that use an electronic pad wear monitoring system. For the BMW Z4, this sensor supports front brake service by providing the wear signal needed when the brake pads reach their service limit. The Pagid 355251651 is listed for 2009-2010 BMW Z4 front applications, with the 2010 BMW Z4 fitment limited to vehicles built to 03/2010. This part cross-references Gates 38172 and Dynamic Friction Company 341-31058 for the same application.

The Made in Europe Wear Sensor line identifies Pagid brake wear sensors built for European vehicle applications where precise fit and connector style matter. If you are replacing a front brake pad wear sensor on a BMW Z4, this part number helps match the original sensor layout and harness length for the specified vehicle coverage.

What It Helps Address

• Brake pad wear warning light staying on after pad service
• Damaged or broken front brake wear sensor wiring
• Faulty pad wear signal from the front brake circuit
• Sensor replacement during front brake pad maintenance
• Connector or harness mismatch on the listed BMW Z4 applications

Installation Notes

Installation requires qualified personnel. Verify the vehicle build date, connector style, and front brake configuration before replacement. Route the 980 mm harness to match the original path and inspect the brake pad wear circuit for damage before clearing any warning indicators. For the listed BMW Z4 applications, confirm the sensor location at the front axle before installation.

Quality Assurance

Pagid supplies brake components for European vehicle service, and this sensor is identified with Technical Information Number P8576 for application reference. Confirm fitment against the vehicle’s brake system details before installation on 2009-2010 BMW Z4 front brake applications.